STM32F101X6 datasheet(72/74 Pages) STMICROELECTRONICS

72 / 74 page

Revision history

STM32F101xx

72/74

22-Nov-2007

Document status promoted from preliminary data to datasheet. Small text

changes.

STM32F101CB part number corrected in Table 1: Device summary.

Number of communication peripherals corrected for STM32F101Tx in

Table 2: Device features and peripheral counts (STM32F101xx access

line) and Number of GPIOs corrected for LQFP package.

Power supply schemes on page 10 modified.

Main function and default alternate function modified for PC14 and PC15

in Table 3: Pin definitions, Note 5 added, Remap column added.

Figure 10: Power supply scheme modified. VDD −VSS ratings modified

and Note 1 modified in Table 4: Voltage characteristics. Note 1 modified

in Table 5: Current characteristics.

Note 2 added in Table 9: Embedded reset and power control block

characteristics.

48 and 72 MHz frequencies removed from Table 11, Table 12 and

Table 13. MCU ‘s operating conditions modified in Typical current

consumption on page 35.

IDD_VBAT typical value at 2.4 V modified and IDD_VBAT maximum value

added in Table 14: Typical and maximum current consumptions in Stop

and Standby modes. Note added in Table 15 on page 35 and Table 16 on

page 36. Table 18: Peripheral current consumption modified.

Figure 15: Current consumption in Stop mode with regulator in Low-

power mode versus temperature at VDD = 3.3 V and 3.6 V added.

Note removed below Figure 24: SPI timing diagram - slave mode and

CPHA=0. Note added below Figure 25: SPI timing diagram - slave mode

and CPHA=1(1).

Figure 28: Typical connection diagram using the ADC modified.

tSU(HSE) and tSU(LSE) conditions modified in Table 21 and Table 22,

respectively. Maximum values removed from Table 25: Low-power mode

wakeup timings. tRET conditions modified in Table 28: Flash memory

endurance and data retention. Conditions modified in Table 29: EMS

characteristics.

Impedance size specified in A.4: Voltage glitch on ADC input 0 on

page 71. Small text changes in Table 34: Output voltage characteristics.

Section 5.3.11: Absolute maximum ratings (electrical sensitivity) updated.

Details on unused pins removed from General input/output

characteristics on page 48.

Table 40: SPI characteristics updated. Notes added and Ilkg removed in

Table 41: ADC characteristics. Note added in Table 42 and Table 45.

Note 2 and Note 3 added below Table 43: ADC accuracy - limited test

conditions. Avg_Slope and V25 modified in Table 45: TS characteristics.

ΘJAvalue for VFQFPN36 package added in Table 50: Thermal

characteristics

. I2C interface characteristics on page 52 modified.

Order codes replaced by Section 7: Ordering information scheme.

Table 52.

Document revision history (continued)

Date

Revision

Changes

STM32F101X6 数据表(PDF) 72 Page - STMicroelectronics

STM32F101X6 数据表(HTML) 72 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

数据表下载