ST7L09 datasheet(73/104 Pages) STMICROELECTRONICS

73 / 104 page

ST7L05, ST7L09

73/104

13 ELECTRICAL CHARACTERISTICS

13.1 PARAMETER CONDITIONS

Unless otherwise specified, all voltages are re-

ferred to VSS.

13.1.1 Minimum and Maximum Values

Unless otherwise specified, the minimum and

maximum values are guaranteed in the worst con-

ditions of ambient temperature, supply voltage and

frequencies by tests in production on 100% of the

devices with an ambient temperature at TA = 25°C

and TA =TAmax (given by the selected tempera-

ture range).

Data based on characterization results, design

simulation and/or technology characteristics are

indicated in the table footnotes and are not tested

in production. Based on characterization, the min-

imum and maximum values refer to sample tests

and represent the mean value plus or minus three

times the standard deviation (mean ± 3

Σ).

13.1.2 Typical Values

Unless otherwise specified, typical data is based

on TA =25°C, VDD = 5V (for the 4.5V ≤ VDD ≤ 5.5V

voltage

range),

VDD = 3.3V

(for

the

≤ V

DD ≤ 3.6V voltage range). They are given

only as design guidelines and are not tested.

13.1.3 Typical Curves

Unless otherwise specified, all typical curves are

given only as design guidelines and are not tested.

13.1.4 Loading Capacitor

The loading conditions used for pin parameter

measurement are shown in Figure 40.

Figure 40. Pin Loading Conditions

13.1.5 Pin Input Voltage

The input voltage measurement on a pin of the de-

vice is described in Figure 41.

Figure 41. Pin Input Voltage

ST7 PIN

VIN

ST7 PIN

ST7L09 数据表(PDF) 73 Page - STMicroelectronics

ST7L09 数据表(HTML) 73 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载