ST10F268 datasheet(70/74 Pages) STMICROELECTRONICS

70 / 74 page

ST10F168

70/74

Figure 29 : CLKOUT and READY

Notes: 1. Cycle as programmed, including MCTC wait states (Example shows 0 MCTC WS).

2. The leading edge of the respective command depends on RW-delay.

3. READY sampled HIGH at this sampling point generates a READY controlled wait state, READY sampled LOW at this sampling

point terminates the currently running bus cycle.

4. READY may be deactivated in response to the trailing (rising) edge of the corresponding command (RD or WR).

5. If the Asynchronous READY signal does not fulfill the indicated setup and hold times with respect to CLKOUT (e.g. because

CLKOUT is not enabled), it must fulfill t 37 in order to be safely synchronized. This is guaranteed, if READY is removed in response

to the command (see Note 4)).

6. Multiplexed bus modes have a MUX wait state added after a bus cycle, and an additional MTTC wait state may be inserted here.

For a multiplexed bus with MTTC wait state this delay is 2 CLKOUT cycles, for a demultiplexed bus without MTTC wait state this

delay is zero.

7. The next external bus cycle may start here.

t30

t34

t35

t36

t35

t36

t58

t59

t58

t59

wait state

READY

MUX / Tristate 6)

t32

t33

t29

Running cycle 1)

t31

t37

t604)

CLKOUT

ALE

RD, WR

Synchronous

Asynchronous

READY

ST10F268 数据表(PDF) 70 Page - STMicroelectronics

ST10F268 数据表(HTML) 70 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

数据表下载