ST92141 datasheet(124/179 Pages) STMICROELECTRONICS

124 / 179 page

124/179

ST92141 - 3-PHASE INDUCTION MOTOR CONTROLLER (IMC)

INDUCTION MOTOR CONTROLLER (Cont’d)

7.4.7 NMI management

Figure 71 shows how the external input NMI signal

is managed by the IMC peripheral.

After an ST9 reset, the NMIE bit in the PCR1 reg-

ister is cleared, which means that NMI signal com-

ing from the external pin is sent, as is, to the ST9

core without affecting the IMC peripheral.

If the NMIE bit is set, when an NMI event occurs

on the external pin, it will be acknowledged (de-

pending on the value of the NMIL bit in the PSR

– The NMI bit in the IMCIVR register is set

– The dedicated output pins of the IMC are put in

high impedance

– A high level signal is sent to the ST9 Top Level

interrupt

– The OPE bit is cleared (as the NMI interrupt sig-

nal is no longer active)

Notes:

1. Because the signal to the ST9 top level interrupt

is active high, the TLTEV bit in the EIVR register

must be set.

2. When the user wants to leave the NMI interrupt

routine, it is strongly recommended to verify, be-

fore leaving the routine, that the NMI pending bit

(bit 3 of IMCIVR) is really at “0”. To do this, the

user can try to write the NMI pending bit to “0” re-

peatedly until it has successfully been cleared.

The NMI pending bit in IMCIVR register can be

written to “0” only if the external NMI signal is no

longer active. This makes sure that no NMI event

will be lost. If the user leaves the NMI interrupt rou-

tine without clearing the NMI pending bit, no other

NMI interrupt can be issued afterwards because

the ST9 top level interrupt is edge sensitive.

Figure 71. NMI management by the IMC peripheral

NMIE

bit

NMI

bit

Level

selection

NMIL

bit

NMI to ST9 core

NMI from EXT pin

ST92141 数据表(PDF) 124 Page - STMicroelectronics

ST92141 数据表(HTML) 124 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载