PC48F4400PLVB0 datasheet(47/102 Pages) NUMONYX

47 / 102 page

November 2007

Datasheet

Order Number: 290701-18

Numonyx™ Wireless Flash Memory (W18)

will not occur because the flash memory may be providing status information instead of

array data. To allow proper CPU/flash initialization at system reset, connect RST# to

the system CPU RESET# signal.

System designers must guard against spurious writes when VCC voltages are above

VLKO. Because both WE# and CE# must be low for a command write, driving either

signal to VIH inhibits writes to the device. The CUI architecture provides additional

protection because alteration of memory contents can only occur after successful

completion of the two-step command sequences. The device is also disabled until RST#

is brought to VIH, regardless of its control input states. By holding the device in reset

(RST# connected to system PowerGood) during power-up/down, invalid bus conditions

during power-up can be masked, providing yet another level of memory protection.

8.4.2

VCC, VPP, and RST# Transitions

The CUI latches commands issued by system software and is not altered by VPP or CE#

transitions or WSM actions. Read-array mode is its power-up default state after exit

from reset mode or after VCC transitions above VLKO (Lockout voltage). After

completing program or block erase operations (even after VPP transitions below VPPLK),

the Read Array command must reset the CUI to read-array mode if flash memory array

access is desired.

8.5

Power Supply Decoupling

When the device is accessed, many internal conditions change. Circuits are enabled to

charge pumps and switch voltages. This internal activity produces transient noise. To

minimize the effect of this transient noise, device decoupling capacitors are required.

Transient current magnitudes depend on the device outputs’ capacitive and inductive

loading. Two-line control and proper decoupling capacitor selection suppresses these

transient voltage peaks. Each flash device should have a 0.1 µF ceramic capacitor

connected between each power (VCC, VCCQ, VPP), and ground (VSS, VSSQ) signal.

High-frequency, inherently low-inductance capacitors should be as close as possible to

package signals.

PC48F4400PLVB0 数据表(PDF) 47 Page - Numonyx B.V