PC48F4400PLVB0 datasheet(88/102 Pages) NUMONYX

88 / 102 page

Numonyx™ Wireless Flash Memory (W18)

Datasheet

November 2007

Order Number: 290701-18

Numonyx™ Wireless Flash Memory (W18)

All partitions default to Read Array mode at power-up. A Read Array command issued to a busy partition results in

undermined data when a partition address is read.

Both cycles of 2 cycles commands should be issued to the same partition address. If they are issued to different partitions,

the second write determines the active partition. Both partitions will output status information when read.

If the WSM is active, both cycles of a 2 cycle command are ignored. This differs from previous Numonyx devices.

The Clear Status command clears Status Register error bits except when the WSM is running (Pgm Busy, Erase Busy, Pgm

Busy In Erase Suspend, OTP Busy, EFP modes) or suspended (Erase Suspend, Pgm Suspend, Pgm Suspend In Erase

Suspend).

EFP writes are allowed only when Status Register bit SR.0 = 0. EFP is busy if Block Address = address at EFP Confirm

command. Any other commands are treated as data.

The "current state" is that of the WSM, not the partition.

Confirm commands (Lock Block, Unlock Block, Lock-down Block, Configuration Register) perform the operation and then

move to the Ready State.

10.

In Erase suspend, the only valid two cycle commands are "Program Word", "Lock/Unlock/Lockdown Block", and "CR

Write". Both cycles of other two cycle commands ("OEM CAM program & confirm", "Program OTP & confirm", "EFP Setup &

confirm", "Erase setup & confirm") will be ignored. In Program suspend or Program suspend in Erase suspend, both cycles

of all two cycle commands will be ignored.

PC48F4400PLVB0 数据表(PDF) 88 Page - Numonyx B.V