MPC8572ECLPXATLD datasheet(72/140 Pages) FREESCALE

72 / 140 page

MPC8572E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 4

Freescale Semiconductor

High-Speed Serial Interfaces (HSSI)

2. Differential Output Voltage, VOD (or Differential Output Swing):

The Differential Output Voltage (or Swing) of the transmitter, VOD, is defined as the difference of

the two complimentary output voltages: VSDn_TX – VSDn_TX. The VOD value can be either positive

or negative.

3. Differential Input Voltage, VID (or Differential Input Swing):

The Differential Input Voltage (or Swing) of the receiver, VID, is defined as the difference of the

two complimentary input voltages: VSDn_RX - VSDn_RX. The VID value can be either positive or

negative.

4. Differential Peak Voltage, VDIFFp

The peak value of the differential transmitter output signal or the differential receiver input signal

is defined as Differential Peak Voltage, VDIFFp = |A – B| Volts.

5. Differential Peak-to-Peak, VDIFFp-p

Because the differential output signal of the transmitter and the differential input signal of the

receiver each range from A – B to –(A – B) Volts, the peak-to-peak value of the differential

transmitter output signal or the differential receiver input signal is defined as Differential

Peak-to-Peak Voltage, VDIFFp-p = 2*VDIFFp = 2 * |(A – B)| Volts, which is twice of differential

swing in amplitude, or twice of the differential peak. For example, the output differential peak-peak

voltage can also be calculated as VTX-DIFFp-p = 2*|VOD|.

6. Differential Waveform

1. The differential waveform is constructed by subtracting the inverting signal (SDn_TX, for

example) from the non-inverting signal (SDn_TX, for example) within a differential pair. There is

only one signal trace curve in a differential waveform. The voltage represented in the differential

waveform is not referenced to ground. Refer to Figure 52 as an example for differential waveform.

2. Common Mode Voltage, Vcm

The Common Mode Voltage is equal to one half of the sum of the voltages between each conductor

of a balanced interchange circuit and ground. In this example, for SerDes output, Vcm_out =

(VSDn_TX + VSDn_TX)/2 = (A + B) / 2, which is the arithmetic mean of the two complimentary

output voltages within a differential pair. In a system, the common mode voltage may often differ

from one component’s output to the other’s input. Sometimes, it may be even different between the

receiver input and driver output circuits within the same component. It is also referred as the DC

offset in some occasion.

MPC8572ECLPXATLD 数据表(PDF) 72 Page - Freescale Semiconductor, Inc