AFS090 datasheet(157/334 Pages) MICROSEMI

157 / 334 page

Fusion Family of Mixed Signal FPGAs

R e visio n 2

2 - 141

Double Data Rate (DDR) Support

Fusion Pro I/Os support 350 MHz DDR inputs and outputs. In DDR mode, new data is present on every

transition of the clock signal. Clock and data lines have identical bandwidths and signal integrity

requirements, making it very efficient for implementing very high-speed systems.

DDR interfaces can be implemented using HSTL, SSTL, LVDS, and LVPECL I/O standards. In addition,

high-speed DDR interfaces can be implemented using LVDS I/O.

Input Support for DDR

The basic structure to support a DDR input is shown in Figure 2-99. Three input registers are used to

capture incoming data, which is presented to the core on each rising edge of the I/O register clock.

Each I/O tile on Fusion devices supports DDR inputs.

Output Support for DDR

The basic DDR output structure is shown in Figure 2-100 on page 2-142. New data is presented to the

output every half clock cycle. Note: DDR macros and I/O registers do not require additional routing. The

combiner automatically recognizes the DDR macro and pushes its registers to the I/O register area at the

edge of the chip. The routing delay from the I/O registers to the I/O buffers is already taken into account

in the DDR macro.

Refer to the application note Using DDR for Fusion Devices for more information.

Figure 2-99 • DDR Input Register Support in Fusion Devices

Input DDR

Data

CLK

CLKBUF

INBUF

Out_QF

(to core)

FF2

FF1

INBUF

CLR

DDR_IN

Out_QR

(to core)

AFS090 数据表(PDF) 157 Page - Microsemi Corporation

AFS090 数据表(HTML) 157 Page - Microsemi Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载