MPC5643L datasheet(97/136 Pages) FREESCALE

97 / 136 page

Electrical characteristics

MPC5643L Microcontroller Data Sheet, Rev. 8.1

Freescale Semiconductor

Figure 10. Spectral representation of input signal

Calling f0 the bandwidth of the source signal (and as a consequence the cut-off frequency of the anti-aliasing filter, fF),

according to the Nyquist theorem the conversion rate fC must be at least 2f0; it means that the constant time of the filter is greater

than or at least equal to twice the conversion period (TC). Again the conversion period TC is longer than the sampling time TS,

which is just a portion of it, even when fixed channel continuous conversion mode is selected (fastest conversion rate at a

specific channel): in conclusion it is evident that the time constant of the filter RFCF is definitively much higher than the

sampling time TS, so the charge level on CS cannot be modified by the analog signal source during the time in which the

sampling switch is closed.

The considerations above lead to impose new constraints on the external circuit, to reduce the accuracy error due to the voltage

drop on CS; from the two charge balance equations above, it is simple to derive Equation 11 between the ideal and real sampled

voltage on CS:

Eqn. 11

From this formula, in the worst case (when VA is maximum, that is for instance 5 V), assuming to accept a maximum error of

half a count, a constraint is evident on CF value:

Eqn. 12

Analog Source Bandwidth (VA)

Sampled Signal Spectrum (fC = conversion Rate)

Anti-Aliasing Filter (fF = RC Filter pole)

2 f0 fC (Nyquist)

fF  f0 (Anti-aliasing Filtering Condition)

TC 2 RFCF (Conversion Rate vs. Filter Pole)

Noise

------------

--------------------------------------------------------

8192





MPC5643L 数据表(PDF) 97 Page - Freescale Semiconductor, Inc