AD9852SLASHPCB datasheet(22/42 Pages) AD

22 / 42 page

AD9852

–22–

REV. 0

FM Chirp

Figure 46 graphically illustrates the effect of CLR ACC2 bit

upon the DDS output frequency. Note that reprogramming the

registers while the CLR ACC2 bit is high allows a new FTW1

frequency and slope to be loaded.

Another function available only in the chirp mode is the HOLD

pin, Pin 29. This function will stop the clocking signal to the ramp

rate counter that will, in turn, halt any further clocking pulses to

the frequency accumulator, ACC1. The effect is to halt the

chirp and hold the output frequency in a static condition at

the frequency existing just before HOLD was pulled high. When

the HOLD pin is returned low, the clocks are resumed and chirp

continues. During a hold condition, user may change the

programming registers; however, the ramp rate counter must

resume operation at its previous rate until a count of zero is

obtained before a new ramp rate count can be loaded. Figure 47

illustrates the effect of the hold function on the DDS output

frequency.

Users may utilize the 32-bit automatic I/O Update counter when

constructing complex chirp or ramped FSK sequences. Since

this internal counter is synchronized with the AD9852 System

UPDATE

CLOCK

MODE

FTW1

DFW

000 (DEFAULT)

RAMP RATE

011 (CHIRP)

DELTA FREQUENCY WORD

CLR ACC1

Figure 45. Effect of CLR ACC1 in FM Chirp Mode

CLR ACC2

MODE

TW1

DPW

000 (DEFAULT)

RAMP RATE

011 (CHIRP)

Figure 46. Effect of CLR ACC2 in FM Chirp Mode

Clock, it allows precisely timed program changes to be invoked.

In this manner, user is only required to reprogram the desired

registers before the automatic I/O Update pulse is generated.

A complete discussion of this function is presented elsewhere in

this data sheet.

In the chirp mode, the destination frequency is not directly

speciﬁed. If the user fails to control the chirp, the DDS will control

itself by naturally conﬁning its output between dc and Nyquist;

however, unless terminated by the user, the chirp will continue

until power is removed.

It is the user’s choice as to what occurs when the chirp destination

frequency is reached. Here are a few of the choices:

1. Stop and hold at the destination frequency using the HOLD

pin, or by loading all zeros into the Delta Frequency Word

registers of the frequency accumulator (ACC1).

2. Stop using the hold pin function, then ramp-down the out-

put amplitude using the digital multiplier stages and the

Shaped Keying pin, Pin 30, or via program register control

(addresses 21–24 hex).

3. Stop and abruptly terminate the transmission using the CLR

ACC2 bit.

AD9852/PCB 数据表(PDF) 22 Page - Analog Devices

AD9852/PCB 数据表(HTML) 22 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

数据表下载