M95128-RMB6TG datasheet(20/49 Pages) STMICROELECTRONICS

20 / 49 page

Instructions

M95128-W M95128-R M95128-DF

20/49

Doc ID 5798 Rev 16

6.4

Write Status Register (WRSR)

The Write Status Register (WRSR) instruction is used to write new values to the Status

previously executed.

The Write Status Register (WRSR) instruction is entered by driving Chip Select (S) low,

followed by the instruction code, the data byte on Serial Data input (D) and Chip Select (S)

driven high. Chip Select (S) must be driven high after the rising edge of Serial Clock (C) that

latches in the eighth bit of the data byte, and before the next rising edge of Serial Clock (C).

Otherwise, the Write Status Register (WRSR) instruction is not executed.

The instruction sequence is shown in Figure 11.

Figure 11.

Write Status Register (WRSR) sequence

Driving the Chip Select (S) signal high at a byte boundary of the input data triggers the self-

timed Write cycle that takes tW to complete (as specified in AC tables under Section 9: DC

and AC parameters).

While the Write Status Register cycle is in progress, the Status Register may still be read to

check the value of the Write in progress (WIP) bit: the WIP bit is 1 during the self-timed

Write cycle tW, and 0 when the Write cycle is complete. The WEL bit (Write Enable Latch) is

also reset at the end of the Write cycle tW.

The Write Status Register (WRSR) instruction enables the user to change the values of the

BP1, BP0 and SRWD bits:

●

The Block Protect (BP1, BP0) bits define the size of the area that is to be treated as

read-only, as defined in Table 2.

●

The SRWD (Status Register Write Disable) bit, in accordance with the signal read on

the Write Protect pin (W), enables the user to set or reset the Write protection mode of

the Status Register itself, as defined in Table 7. When in Write-protected mode, the

Write Status Register (WRSR) instruction is not executed.

The contents of the SRWD and BP1, BP0 bits are updated after the completion of the

WRSR instruction, including the tW Write cycle.

The Write Status Register (WRSR) instruction has no effect on the b6, b5, b4, b1, b0 bits in

the Status Register. Bits b6, b5, b4 are always read as 0.

AI02282D

3456789 10 11 12 13 14 15

High Impedance

Instruction

Status

765432

MSB

M95128-RMB6TG 数据表(PDF) 20 Page - STMicroelectronics

M95128-RMB6TG 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

数据表下载