SAP5SD-B-G1-R datasheet(10/63 Pages) ETC2

10 / 63 page

SAP5S / SAP51

Universal Actuator-Sensor Interface IC

Data Sheet

July 17, 2012

the prior written consent of the copyright owner. The information furnished in this publication is PRELIMINARY and subject to

changes without notice.

10 of 62

1.2. Operating Conditions

Table 2: Operating Conditions

Symbol

Parameter

Min

Max.

Unit

Note

VLTGN

Negative supply voltage

VLTGP

DC voltage at LTGP relating to VLTGN

1, 2

ILTGP

Operating current at VUIN = 30V

ICL1

Max. output sink current at pins D3...D0, DSTBn

ICL2

Max. output sink current at pins P0...P3, PSTBnBn



amb

Ambient temperature range, operating range

-25

°C

1 Below V

LTGPmin the power supply block may not be able to provide the specified output currents at

UOUT and U5R.

2 Outside of these limits the send current shape and send current amplitude cannot be guaranteed.

3 f

c = 16.000 MHz, no load at any pin, transmitter turned off, digital state machine is in idle state

Table 3: Crystal Frequency

Symbol

Parameter

Nom.

Unit

Note

Crystal frequency

5.333/16.000

MHz

4 The IC automatically detects whether the crystal frequency is 5.333MHz or 16.000MHz and controls

the internal clock circuit accordingly.

1.3. EMC Behavior

The IC has to fulfill the requirements defined in AS-Interface Complete Specification V2.11 [1] and related test

requirements AS-Interface Slave ICs.

In addition to the AS-Interface Complete Specification and in combination with a reference component circuit

the IC has to achieve a communication failure rate less than 10% of the allowed failure rate according to the

"Fast Transient" test method specified in the related AS-Interface association test procedures.

The above specified behavior is correct by design and has to be proven while IC characterization.

1.4. Quality Standards

The quality of the IC will be ensured according to the ZMDI quality standards. ZMDI is a qualified supplier

according to ISO/TS 16949:2002 and ISO 14001:1996.

The following reference documents apply for the development process:

Management Regulation: 0410 Product Development procedure

Process Specification: ZMDI C7D 0.6µm Technology

Functional device parameters are valid for device operating conditions specified in chapter 1.2 at page 8.

Production device tests are performed within the recommended ranges of VLTGP - VLTGN, amb = +25°C

(+85°C and -25°C on sample base only) unless otherwise stated.

SAP5SD-B-G1-R 数据表(PDF) 10 Page - List of Unclassifed Manufacturers

SAP5SD-B-G1-R 数据表(HTML) 10 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

数据表下载