STV0974 datasheet(48/69 Pages) STMICROELECTRONICS

48 / 69 page

48/61

STV0974

Functional description

Note:

Access to the bits mentioned here above is done through a read-modify-write sequence. As an

example, when torch mode is set:

- when in idle mode:

set 0x8A44 bit[6] to 0 to enable the torch mode

set 0x8A43 bit[2:0] to 7 to light the torch (if the torch is active high)

- go into required Active mode (still/live or ViewFinder):

set 0x8A43 bit[2:0] to 0 to extinguish the torch

In the case of flash mode:

- when in idle mode:

set 0x8A45 bit[6] to 1 to set the flash pulse active low (default setting is flash pulse active high)

set 0x88D4 bit[2:0] to 7 to set the flash pulse length to 8 video lines

set 0xA104 bit [7:0] to 0 to set 0 transfer frame delay

set 0xA500 bit[3:0] to 5 to set white balance to “daylight” fixed setting

- go into flash mode:

the system automatically goes back to Idle.

Table 33: Flash mode management [register group 6]

Name

Index

R/W

State

code

Data

type

Format

default

Description

Torch polarity

0x8A43

R/W

RRRR.RDDD

RRR.R000

Bit[2:0]=0: Torch output (pin

DIO12) signal is low

Bit[2:0]=7: Torch output (pin

DIO12) signal is high

Torch control

0x8A44

R/W

RDRR.RRRR

R1RR.RRRR

Bit[6]=0: Torch output (pin DIO12)

pad enable.

Bit[6]=1: Torch output (pin DIO12)

pad in high impedance

Flash pulse

polarity

0x8A45

R/W

RDRR.RRRR

R0RR.RRRR

Bit[6]=0: Flash pulse active high.

Bit[6]=1: Flash pulse active low.

Flash pulse length

0x88D4

R/W

RRRR.RDDD

0000.0000

Bit[2:0]: line length - 1

Default is 0, corresponding to 1

video line (maximum pulse allowed

is 8 video lines).

STV0974 数据表(PDF) 48 Page - STMicroelectronics

STV0974 数据表(HTML) 48 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69

数据表下载