TCS3530 datasheet(73/106 Pages) OSRAM

73 / 106 page

Page 72

Datasheet, Public

Document Feedback

[v3-00] 2023-Jun-23

TCS3530 − Register O ver view

MEAS_SEQR_WAIT_AND_TS_ENABLE Register

Figure 101:

MEAS_SEQR_WAIT_AND_TS_ENABLE

Note(s):

1. Return to the Register Map (0xDF).

MOD_CALIB_CFG0 Register

Figure 102:

MOD_CALIB_CFG0

Note(s):

1. Return to the Register Map (0xE0).

Addr: 0xDF

MEAS_SEQR_WAIT_AND_TS_ENABLE

Bit

Field

Reset

Type

Bit Description

7:4

Reserved

3:0

MEASUREMENT_

SEQUENCER_

WAIT_ PATTERN

0001b

R/W

Defines if a sequencer step will wait for the modulator

trigger timer to finish as programmed in MOD_TRIGGER_

TIMING and WTIME. At the same time the timer is

restarted. In case this bit is not set, the next sequencer

step will start as soon as all measurements in the prior

step are completed.

Please observe that MOD_TRIGGER_TIMIMG is “0” by

default. In this case the programmed wait pattern is

ignored since measurement time has always priority over

wait time.

The bit pattern does not represent a value but controls

bitwise which sequencer step shall be used. The leftmost

position of “0000” refers to sequencer step 3, the

rightmost refers to sequencer step 0. By default the wait is

executed for sequencer step 3 (last sequencer step).

Addr: 0xE0

MOD_CALIB_CFG0

Bit

Field

Reset

Type

Bit Description

7:0

MODE_CALIB_

NTH_ITERATION

0xFF

R/W

Defines the repetition rate of calibrations in sequencer

rounds or steps depending on MOD_CALIB_NTH_

ITERATION_STEP_ENABLE.

0x00: Never

0x01-0xFE: Every nth time

0xFF: Only once at start

TCS3530 数据表(PDF) 73 Page - OSRAM GmbH

TCS3530 数据表(HTML) 73 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载