TCS3530 datasheet(53/106 Pages) OSRAM

53 / 106 page

Page 52

Datasheet, Public

Document Feedback

[v3-00] 2023-Jun-23

TCS3530 − Register O ver view

VSYNC_GPIO_INT Register

Figure 63:

VSYNC_GPIO_INT

Note(s):

1. Return to the Register Map (0xB0).

Addr: 0xB0

VSYNC_GPIO_INT

Bit

Field

Reset

Type

Bit Description

7Reserved

INT_INVERT

R/W

If set to “1” the INT pin output is inverted. This applies to

all output signals as selected in INT_PINMAP.

5INT_IN_EN

R/W

If programmed to “1” the INT pin is set as input. Please

observe that the connected net must not be floating since

INT is an open drain input.

INT_IN

External HIGH or LO value applied to INT pin.

VSYNC_GPIO_

INVERT

0R/W

If set to “1” the VSYNC/GPIO pin output is inverted. This

applies to all output signals as selected in VSYNC_GPIO_

PINMAP.

VSYNC_GPIO_

IN_EN

0R/W

If programmed to “1” the VSYNC/GPIO pin is set as in-put.

Please observe that the connected net must not be

floating since VSYNC/GPIO is an open drain input.

VSYNC_GPIO_OUT

R/W

Programs the VSYNC/GPIO pin HI or LOW. Since the pin is

an open drain I/O pin, the default value is HIGH to avoid

any unintended power consumption through pull-up

resistor. The routed internal signal is selected in VSYNC_

GPIO_PINMAP.

VSYNC_GPIO_IN

External HIGH or LO value applied to VSYNC/GPIO pin.

TCS3530 数据表(PDF) 53 Page - OSRAM GmbH

TCS3530 数据表(HTML) 53 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载