4LS datasheet(18/115 Pages) OSRAM

18 / 115 page

Document Feedback

4LS

Typical Operating Characteristics

Datasheet

• PUBLIC

DS000542

• v3-01 • 2022-Nov-17

114

│ 17

Figure 19:

Electro-Optical Characteristics of 4LS Monochrome(1)(2)

Parameter

12-bit @ 60 MHz

8-bit @ 80 MHz

Unit

Variant

Full Well Capacity

22.21

10.58

ke-

QE @ 530 nm

60.81

54.09

Conversion Gain

0.1612

0.0218

DN/e-

Responsivity

0.098

82.46

0.01179

9.86

DN/ph

DN/nJ/cm2

Temporal Dark Noise

8.18

50.75

1.01

46.20

FSD

3580

231

Dynamic Range

52.82

47.20

SNRMax

43.19

39.35

DSNU

15.30

9.16

3.68

2.07

1.25

0.71

15K

10K

PRNU

1.02

0.87

0.92

1.2

0.97

0.93

15K

10K

(1)

The results were obtained using 530 nm illumination. The ADC ramp gain was adjusted to the equivalent of 1 V swing,

for 12-bit ADC mode, and 0.5 V swing for 8-bit ADC mode (therefore, approximately half of FWC for 8-bit). The sensors

temperature was approximately 60ºC (uncontrolled temperature environment). The values presented are for the default

configuration of Full Well around 20 ke- (STS3 Register bits [3:0] = 0x0). Sensor supply levels were the typical ones:

VDDA = 3.3 V and VDDD = 1.8 V. The set Readout mode was 1-To-1. DSNU and PRNU results were characterized for

each variant. The remaining parameters are valid for all variants, once they all share the same silicon.

(2)

The settings used to get these values are those recommended by the European Machine Vision Association standard

1288 from the Machine Vision Sensors and Cameras. https://www.emva.org/standards-technology/emva-1288/

4LS 数据表(PDF) 18 Page - OSRAM GmbH

4LS 数据表(HTML) 18 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载