STA382BWSTR datasheet(168/172 Pages) STMICROELECTRONICS

168 / 172 page

Applications

STA382BWS

168/172

Doc ID 022784 Rev 1

Besides the digital input to the power output path, a line in to the headphone / 2Vrms line out

path is provided. The headphone and line out block diagram is shown in Figure 47. The

overall gain is determined by the external resistors R1 and R2 as:

Gain=R2/R1*2

The LINEINR/LINEINL pins can be either connected to an external line in or to the

F3XL/F3XR pins as depicted in Figure 44 and Figure 45. Thanks to this latter option it is

possible to route the digital input (SAI) content on both the power and the line

out/headphone output.

Note:

The charge pump of the headphone and line out cannot drive a purely capacitive load.

Please refer to AN3959 (2.0-channel demonstration board based on the STA382BWS and

STA381BWS) for detailed information about headphone and line out filtering.

8.3

Typical output configuration

Figure 48 illustrates the typical output configuration used for BTL stereo mode. Please refer

to the application note for all the other schematics for the recommended output

configuration.

Figure 48.

Output configuration for stereo BTL mode in filterlight configuration

Note:

For further information, please refer to application note AN3959, 2.0-channel demonstration

board based on the STA382BWS and STA381BWS.

Obsolete

Product(s)

- Obsolete

Product(s)

STA382BWSTR 数据表(PDF) 168 Page - STMicroelectronics