M38C31M7AXXXFS datasheet(40/224 Pages) RENESAS

40 / 224 page

38C3 Group User’s Manual

HARDWARE

1-25

Fig. 20 Timing chart of timer 6 PWM1 mode

16-bit Timer

Timer A is a 16-bit timer that can be selected in one of four modes by

the timer A mode register and the timer A control register.

qTimer A

The timer A operates as down-count. When the timer contents reach

“000016”, an underflow occurs at the next count pulse and the timer

latch contents are reloaded. After that, the timer continues count-

down. When the timer underflows, the interrupt request bit correspond-

ing to the timer A is set to “1”.

(1) Timer mode

The count source can be selected by setting the timer A mode regis-

ter.

(2) Pulse output mode

Pulses of which polarity is inverted each time the timer underflows

are output from the TAOUT pin. Except for that, this mode operates

just as in the timer mode.

When using this mode, set port P50 sharing the TAOUT pin to output

mode.

(3) IGBT output mode

After dummy output from the TAOUT pin, count starts with the INT0

pin input as a trigger. When the trigger is detected or the timer A

underflows, “H” is output from the the TAOUT pin.

When the count value corresponds with the compare register value,

the TAOUT output becomes “L”. When the INT0 signal becomes “H”,

the TAOUT output is forced to become “L”.

After noise is cleared by noise filters, judging continuous 4-time same

levels with sampling clocks to be signals, the INT0 signal can use 4

types of delay time by a delay circuit.

When using this mode, set port P55 sharing the INT0 pin to input

mode and set port P50 sharing the TAOUT pin to output mode.

It is possible to force the timer A output to be “L” using pins INT1 and

INT2 by the timer A control register.

(4) PWM mode

IGBT dummy output, an external trigger with the INT0 pin and output

control with pins INT1 and INT2 are not used. Except for those, this

mode operates just as in the IGBT output mode.

The period of PWM waveform is specified by the timer A set value.

The “H” term is specified by the compare register set value.

When using this mode, set port P50 sharing the TAOUT pin to output

mode.

FUNCTIONAL DESCRIPTION

Timer 6

count source

n ! ts

m ! ts

(n+m) ! ts

Note: PWM waveform (duty : n/(n+m) and period : (n+m) ! ts) is output.

n: setting value of Timer 6

m: setting value of Timer 6 PWM register

ts: period of Timer 6 count source

Timer 6 interrupt request

Timer 6

PWM mode

M38C31M7AXXXFS 数据表(PDF) 40 Page - Renesas Technology Corp

M38C31M7AXXXFS 数据表(HTML) 40 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载