L9803 datasheet(24/126 Pages) STMICROELECTRONICS

部件名	L9803

功能描述	Super smart power motor driver with 8-Bit MCU, RAM, EEPROM, ADC, WDG, Timers, PWM and H-bridge driver

PDF	126 Pages

Scroll/Zoom	100%

制造商	STMICROELECTRONICS [STMicroelectronics]

网页	http://www.st.com

标志

24 / 126 page

Clocks, Reset, Interrupts & Power saving modes

L9803

24/126

Reset Value:0000 0000 (00h)

b0 - Slow Mode Select

0- Normal mode - Oscillator frequency / 2 (Reset state)

1- Slow mode (Bits b1 and b2 define the prescaler factor)

b1, b2 - CPU clock prescaler for Slow Mode

b3, b4 - External Interrupt Option

The selection issued from b3/b4 combination is applied to PA[0]..PA[7],PB0,PB1 external

interrupt. The selection can be made only if I bit in CC register is reset (interrupt enabled).

b3, b4 can be written only when the Interrupt Mask (I) of the CC (Condition Code) register is

set to 1.

b5,b6,b7 = not used

3.5

Reset

3.5.1

Introduction

There are four sources of Reset:

–

NRESET pin (external source)

–

Power-On Reset / Low Voltage Detection (Internal source)

–

WATCHDOG (Internal Source)

–

SAFEGUARD (Internal source)

The Reset Service Routine vector is located at address FFFEh-FFFFh.

b4b3

b1b0

Option

Oscillator frequency / 4

Oscillator frequency / 8

Oscillator frequency / 16

Oscillator frequency / 32

Option

Falling edge and low level (Reset state)

Falling edge only

Rising edge only

Rising and Falling edge

L9803 数据表(PDF) 24 Page - STMicroelectronics

L9803 数据表(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载