L9803 datasheet(51/126 Pages) STMICROELECTRONICS

51 / 126 page

L9803

On-Chip Peripherals

51/126

= Pulse period (in seconds)

CPU

= CPU clock frequency (in hertz)

PRESC = Timer prescaler factor (2, 4 or 8 depending on the CC[1:0] bits,

seeTable 9: Clock Control Bits).

If the timer clock is an external clock the formula is:

Where:

= Pulse period (in seconds)

EXT

= External timer clock frequency (in hertz)

When the value of the counter is equal to the value of the contents of the OC1R register, the

OLVL1 bit is output on the OCMP1 pin (See Figure 27).

Note:

The OCF1 bit cannot be set by hardware in One Pulse mode but the OCF2 bit can generate

an Output Compare interrupt.

When the Pulse Width Modulation (PWM) and One Pulse mode (OPM) bits are both set, the

PWM mode is the only active one.

If OLVL1=OLVL2 a continuous signal will be seen on the OCMP1 pin.

The ICAP1 pin can not be used to perform input capture. The ICAP2 pin can be used to

perform input capture (ICF2 can be set and IC2R can be loaded) but the user must take

care that the counter is reset each time a valid edge occurs on the ICAP1 pin and ICF1 can

also generates interrupt if ICIE is set.

When One Pulse mode is used OC1R is dedicated to this mode. Nevertheless OC2R and

OCF2 can be used to indicate that a period of time has elapsed but cannot generate an

output waveform because the OLVL2 level is dedicated to One Pulse mode.

Note:

The OCF1 bit cannot be set by hardware in one pulse mode but the OCF2 bit can generate

an Output Compare interrupt.

The ICF1 bit is set when an active edge occurs and can generate an interrupt if the ICIE bit

is set.

When the Pulse Width Modulation (PWM) and One Pulse Mode (OPM) bits are both set, the

PWM mode is the only active one.

Figure 27.

One

Pulse Mode Timing

Pulse Width Modulation Mode

Pulse Width Modulation (PWM) mode enables the generation of a signal with a frequency

and pulse length determined by the value of the OC1R and OC2R registers.

COUNTER

....

FFFC FFFD FFFE

2ED0

2ED1 2ED2

2ED3

FFFC FFFD

OLVL2

OLVL1

ICAP1

OCMP1

compare1

Note: IEDG1=1, OCR1=2ED0h, OLVL1=0, OLVL2=1

L9803 数据表(PDF) 51 Page - STMicroelectronics

L9803 数据表(HTML) 51 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载