STM32F303VC datasheet(25/133 Pages) STMICROELECTRONICS

25 / 133 page

STM32F302xx/STM32F303xx

Functional overview

Doc ID 023353 Rev 5

25/133

3.16.5

Window watchdog (WWDG)

The window watchdog is based on a 7-bit downcounter that can be set as free running. It

can be used as a watchdog to reset the device when a problem occurs. It is clocked from the

main clock. It has an early warning interrupt capability and the counter can be frozen in

debug mode.

3.16.6

SysTick timer

This timer is dedicated to real-time operating systems, but could also be used as a standard

down counter. It features:

●

A 24-bit down counter

●

Autoreload capability

●

Maskable system interrupt generation when the counter reaches 0.

●

Programmable clock source

3.17

Real-time clock (RTC) and backup registers

The RTC and the 16 backup registers are supplied through a switch that takes power from

either the VDD supply when present or the VBAT pin. The backup registers are sixteen 32-bit

registers used to store 64 bytes of user application data when VDD power is not present.

They are not reset by a system or power reset, or when the device wakes up from Standby

mode.

The RTC is an independent BCD timer/counter. It supports the following features:

●

Calendar with subsecond, seconds, minutes, hours (12 or 24 format), week day, date,

month, year, in BCD (binary-coded decimal) format.

●

Automatic correction for 28, 29 (leap year), 30 and 31 days of the month.

●

Two programmable alarms with wake up from Stop and Standby mode capability.

●

On-the-fly correction from 1 to 32767 RTC clock pulses. This can be used to

synchronize it with a master clock.

●

Digital calibration circuit with 1 ppm resolution, to compensate for quartz crystal

inaccuracy.

●

Three anti-tamper detection pins with programmable filter. The MCU can be woken up

from Stopand Standby modes on tamper event detection.

●

Timestamp feature which can be used to save the calendar content. This function can

be triggered by an event on the timestamp pin, or by a tamper event. The MCU can be

woken up from Stop and Standby modes on timestamp event detection.

●

17-bit Auto-reload counter for periodic interrupt with wakeup from STOP/STANDBY

capability.

The RTC clock sources can be:

●

A 32.768 kHz external crystal

●

A resonator or oscillator

●

The internal low-power RC oscillator (typical frequency of 40 kHz)

●

The high-speed external clock divided by 32.

STM32F303VC 数据表(PDF) 25 Page - STMicroelectronics

STM32F303VC 数据表(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载