STM32F303VC datasheet(28/133 Pages) STMICROELECTRONICS

28 / 133 page

Functional overview

STM32F302xx/STM32F303xx

28/133

Doc ID 023353 Rev 5

3.21

Serial peripheral interface (SPI)/Inter-integrated sound

interfaces (I2S)

Up to three SPIs are able to communicate up to 18 Mbits/s in slave and master modes in

full-duplex and half-duplex communication modes. The 3-bit prescaler gives 8 master mode

frequencies and the frame size is configurable from 4 bits to 16 bits.

Two standard I2S interfaces (multiplexed with SPI2 and SPI3) supporting four different audio

standards can operate as master or slave at half-duplex and full duplex communication

modes. They can be configured to transfer 16 and 24 or 32 bits with 16-bit or 32-bit data

resolution and synchronized by a specific signal. Audio sampling frequency from 8 kHz up to

192 kHz can be set by 8-bit programmable linear prescaler. When operating in master mode

it can output a clock for an external audio component at 256 times the sampling frequency.

Refer to Table 7 for the features available in SPI1, SPI2 and SPI3.

3.22

Controller area network (CAN)

The CAN is compliant with specifications 2.0A and B (active) with a bit rate up to 1 Mbit/s. It

can receive and transmit standard frames with 11-bit identifiers as well as extended frames

with 29-bit identifiers. It has three transmit mailboxes, two receive FIFOs with 3 stages and

14 scalable filter banks.

3.23

Universal serial bus (USB)

The STM32F302xx/STM32F303xx devices embed an USB device peripheral compatible

with the USB full-speed 12 Mbs. The USB interface implements a full-speed (12 Mbit/s)

function interface. It has software-configurable endpoint setting and suspend/resume

support. The dedicated 48 MHz clock is generated from the internal main PLL (the clock

source must use a HSE crystal oscillator). The USB has a dedicated 512-bytes SRAM

memory for data transmission and reception.

3.24

Infrared Transmitter

The STM32F302xx/STM32F303xx devices provide an infrared transmitter solution. The

solution is based on internal connections between TIM16 and TIM17 as shown in the figure

below.

Table 7.

STM32F30xB/C SPI/I2S implementation

SPI features(1)

X = supported.

SPI1

SPI2

SPI3

Hardware CRC calculation

Rx/Tx FIFO

NSS pulse mode

I2S mode

TI mode

XXX

STM32F303VC 数据表(PDF) 28 Page - STMicroelectronics

STM32F303VC 数据表(HTML) 28 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载