EPF10K100 datasheet(21/128 Pages) ALTERA

21 / 128 page

Altera Corporation

FLEX 10K Embedded Programmable Logic Device Family Data Sheet

Up/Down Counter Mode

The up/down counter mode offers counter enable, clock enable,

synchronous up/down control, and data loading options. These control

signals are generated by the data inputs from the LAB local interconnect,

the carry-in signal, and output feedback from the programmable register.

The Up/down counter mode uses 2 three-input LUTs: one generates the

counter data, and the other generates the fast carry bit. A 2-to-1

multiplexer provides synchronous loading. Data can also be loaded

asynchronously with the clear and preset register control signals, without

using the LUT resources.

Clearable Counter Mode

The clearable counter mode is similar to the up/down counter mode, but

supports a synchronous clear instead of the up/down control. The clear

function is substituted for the cascade-in signal in the up/down counter

mode. Clearable counter mode uses 2 three-input LUTs: one generates the

counter data, and the other generates the fast carry bit. Synchronous

loading is provided by a 2-to-1 multiplexer. The output of this multiplexer

is ANDed with a synchronous clear signal.

Internal Tri-State Emulation

Internal tri-state emulation provides internal tri-stating without the

limitations of a physical tri-state bus. In a physical tri-state bus, the

tri-state buffers’ output enable (OE) signals select which signal drives the

bus. However, if multiple OE signals are active, contending signals can be

driven onto the bus. Conversely, if no OE signals are active, the bus will

float. Internal tri-state emulation resolves contending tri-state buffers to a

low value and floating buses to a high value, thereby eliminating these

problems. The Altera software automatically implements tri-state bus

functionality with a multiplexer.

Clear & Preset Logic Control

Logic for the programmable register’s clear and preset functions is

controlled by the DATA3, LABCTRL1, and LABCTRL2 inputs to the LE. The

clear and preset control structure of the LE asynchronously loads signals

into a register. Either LABCTRL1 or LABCTRL2 can control the

asynchronous clear. Alternatively, the register can be set up so that

LABCTRL1

implements an asynchronous load. The data to be loaded is

driven to DATA3; when LABCTRL1 is asserted, DATA3 is loaded into the

EPF10K100 数据表(PDF) 21 Page - Altera Corporation

EPF10K100 数据表(HTML) 21 Page - Altera Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载