TAS3208IPZP datasheet(31/79 Pages) TI1

31 / 79 page

Stop

Condition

Acknowledge

I C Device Address

and

Read/Write Bit

I C Device Address

and

Read/Write Bit

Sub Address

First Data Byte

Other Data Bytes

Last Data Byte

Acknowledge

Not

Acknowledge

Ack

R/W Ack

Ack

R/W Ack

Start

Condition

Repeat Start

Condition

TAS3208

www.ti.com

SLES201E

– JANUARY 2007 – REVISED MARCH 2011

If the master device issues more data received acknowledges than required to receive the data for a given

subaddress, the master device simply receives complete or partial sets of data, depending on how many data

received acknowledges are issued from the subaddress(es) that follow. I2C read transactions, both sequential

and random, can impose wait states.

For the standard I2C mode (SCL = 100 kHz), worse-case wait state times for an 8-MHz microprocessor clock is

on the order of 2

µs. Nominal wait state times for the same 8-MHz microprocessor clock is on the order of 1 µs.

For the fast I2C mode (SCL = 400 kHz) and the same 8-MHz microprocessor clock, worse-case wait state times

can extend up to 10.5

µs in duration. Nominal wait state times for this same case lie in a range from 2 µs to 4.6

µs. Increasing the microprocessor clock frequency lowers the wait state times and for the standard I2C mode, a

higher microprocessor clock can totally eliminate the presence of wait states.

For example, increasing the microprocessor clock to 16 MHz results in no wait states. For the fast I2C mode,

higher microprocessor clocks shortens the wait state times encountered, but does not totally eliminate their

presence.

I2C Master-Mode Operation

I2C master-mode operation is enabled following a reset or power-on reset.

The TAS3208 uses the master mode to download from EEPROM the memory contents for:

•

Microprogram memory

•

Micro extended memory

•

DSP program memory

•

DSP coefficient memory

•

DSP data memory

The TAS3208, when operating as an I2C master, can execute a complete download of any internal memory or

any section of any internal memory without requiring any wait states.

When the TAS3208 operates as an I2C master, it generates a repeated Start without an intervening Stop

command while downloading program and memory DATA from an external EEPROM. When a repeated Start is

sent to the EEPROM in read mode, the EEPROM enters a sequential read mode to quickly transfer large blocks

of data.

Figure 22. Multiple-Byte Read Transfer

The TAS3208 will query the bus for an I2C EEPROM at an address 1010xxx. The value xxx can be chip selects,

other information, or don

’t cares depending on the EEPROM selected.

The first act of the TAS3208 as master will be to transmit a Start condition along with the device address of the

I2C EEPROM, with the read/write bit cleared (0) to indicate a write. The EEPROM acknowledges the address

byte and the TAS3208 sends a subaddress byte, which the EEPROM will acknowledge. Most EEPROMs have at

least 2-byte addresses and will acknowledge as many as are appropriate. At this point, the EEPROM sends a

last acknowledge and becomes a slave transmitter. The TAS3208 acknowledges each byte repeatedly to

continue reading each data byte that is stored in memory.

The memory load information starts with reading the header and data information that starts at subaddress 0 of

the EEPROM. This information must be stored in a sequential memory addresses with no intervening gaps. The

data block is contiguous blocks of data that immediately follow the headers' locations. The TAS3208 memory

data can be stored and loaded in (almost) any order. Additionally this addressing scheme permits portions of the

TAS3208 internal memories to be loaded.

Submit Documentation Feedback

Product Folder Link(s): TAS3208

TAS3208IPZP 数据表(PDF) 31 Page - Texas Instruments

TAS3208IPZP 数据表(HTML) 31 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

数据表下载

链接网址

TAS3208IPZP 数据表(PDF) 31 Page - Texas Instruments

TAS3208IPZP 数据表(HTML) 31 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

数据表 下载

链接网址

数据表下载