| 数据搜索系统,热门电子元器件搜索 |
|
LPC47M14X 数据表(PDF) 73 Page - SMSC Corporation |
|
|
|||||||||||||||||||||||||||||
LPC47M14X 数据表(HTML) 73 Page - SMSC Corporation |
|
73 / 205 page ![]() SMSC DS – LPC47M14X Page 73 Rev. 03/19/2001 6.8 MPU-401 MIDI UART 6.8.1 Overview Serial Port 3 is used exclusively in the LPC47M14x as an MPU-401-compatible MIDI Interface. The LPC47M14x MPU-401 hardware includes a Host Interface, an MPU-401 command controller, configuration registers, and a compatible UART (FIGURE 3). Each of these components are discussed in detail, below. Only the MPU-401 UART (pass-through) mode is included in this implementation. MPU-401 UART mode is supported on the Sound Blaster 16 Series-compatible MIDI hardware. The Sound Blaster 16 hardware is supported by Microsoft Windows Operating Systems. In MPU-401 UART mode, data is transferred without modification between the host and the MIDI device (UART). Once UART mode is entered using the UART MODE command (3Fh), the only MPU-401 command that the interface recognizes is RESET (FFh). HOST INTERFACE IRQ SA[15:0] SD[7:0] UART MIDI_IN MIDI_OUT MPU-401 COMMAND CONTROLLER TX RX nIOR nIOW CONFIGURATION REGISTERS FIGURE 3 – MPU-401 MIDI INTERFACE Note: This figure is for illustration purposes only and is not intended to suggest specific implementation details. 6.8.2 Host Interface Overview The Host Interface includes two contiguous 8-bit run-time registers (the Status/Command Port and the Data Port), and an interrupt. For illustration purposes, the Host Interface block shown in FIGURE 3 uses standard ISA signaling. Address decoding and interrupt selection for the Host Interface are determined by device configuration registers (see Section “MPU-401Configuration Registers”). I/O Addresses The Sound Blaster 16 MPU-401 UART mode MIDI interface requires two consecutive I/O addresses with possible base I/O addresses of 300h and 330h. The default is 330h. The LPC47M14x MPU-401 I/O base address is programmable on even-byte boundaries throughout the entire I/O address range (see Section “Activate and I/O Base address”). |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |