L99LD21 datasheet(23/73 Pages) STMICROELECTRONICS

23 / 73 page

DS11130 Rev 5

23/73

L99LD21

Functional description

Note:

Vs must be stable above minimum value specified (5.5 V) before rising edge on DIN or

falling edge on CSN.

4.1.2

Pre-standby mode

The device enters Pre-standby mode under the following conditions:

•

upon the two following consecutive SPI frames setting:

–

UNLOCK = 1

–

(EN, GOSTBY) = (0, 1)

The Pre-standby mode characteristics are:

•

V3V3 > VPOR

•

Boost disabled

•

Bucks disabled

•

SPI active

The device leaves automatically Pre-standby mode entering standby:

•

if CSN High and DIN Low for a time t > tSTDBY

4.1.3

Reset mode

The device enters Reset mode under the following conditions:

•

By default, once the device leaves Standby mode;

•

If device state is Active mode, when one of the following events occur:

–VSPI under voltage;

–

Watchdog failure

–

One SPI frame setting (EN,GOSTBY) = (0,0)

–

Two consecutive SPI frames setting

UNLOCK = 1

(EN,GOSTBY) = (1,1)

The Reset mode characteristics are:

•

V3V3 > VPOR

•

All the control and status registers set to their default values

•

SPI inactive

The device leaves automatically Reset mode and enters Limp home after 400 ns (typical).

4.1.4

Limp home

The device enters Limp Home automatically 400 ns after Reset mode.

L99LD21 数据表(PDF) 23 Page - STMicroelectronics

L99LD21 数据表(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73

数据表下载