PIC16F1507-ESLASHSS. datasheet(83/278 Pages) MICROCHIP

83 / 278 page

 2011-2015 Microchip Technology Inc.

DS40001586D-page 83

PIC16(L)F1507

10.2.3

ERASING FLASH PROGRAM

MEMORY

While executing code, program memory can only be

erased by rows. To erase a row:

Load the PMADRH:PMADRL register pair with

any address within the row to be erased.

Clear the CFGS bit of the PMCON1 register.

Set the FREE and WREN bits of the PMCON1

Write 55h, then AAh, to PMCON2 (Flash

programming unlock sequence).

Set control bit WR of the PMCON1 register to

begin the erase operation.

See Example 10-2.

After the “BSF PMCON1,WR” instruction, the processor

requires two cycles to set up the erase operation. The

user must place two NOP instructions immediately

following the WR bit set instruction. The processor will

halt internal operations for the typical 2 ms erase time.

This is not Sleep mode as the clocks and peripherals

will continue to run. After the erase cycle, the processor

will resume operation with the third instruction after the

PMCON1 write instruction.

FIGURE 10-4:

FLASH PROGRAM

MEMORY ERASE

FLOWCHART

Start

Erase Operation

End

Erase Operation

Disable Interrupts

(GIE =

Select

Program or Configuration Memory

(CFGS)

Select Erase Operation

(FREE =

Select Row Address

(PMADRH:PMADRL)

Enable Write/Erase Operation

(WREN =

Unlock Sequence

(See Note 1)

Re-enable Interrupts

(GIE =

Disable Write/Erase Operation

(WREN =

CPU stalls while

Erase operation completes

(2 ms typical)

Rev. 10-000048A

7/30/2013

Note 1:

See Figure 10-3.

PIC16F1507-E/SS. 数据表(PDF) 83 Page - Microchip Technology

PIC16F1507-E/SS. 数据表(HTML) 83 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载