M32CSLASH86 datasheet(192/505 Pages) RENESAS

192 / 505 page

Page 169

15. Timer (Timer B)

)

(

15.2.3 Pulse Period/Pulse Width Measurement Mode

In pulse period/pulse width measurement mode, the timer measures pulse period or pulse width of an

external signal. (See Table 15.11) Figure 15.22 shows the TBiMR register (i=0 to 5) in pulse period/pulse

width measurement mode. Figure 15.23 shows an operation example in pulse period measurement

mode. Figure 15.24 shows an operation example in the pulse width measurement mode.

Table 15.11 Pulse Period/Pulse Width Measurement Mode Specifications

Item

Specification

Count Source

f1, f8, f2n(3), fC32

Counting Operation

• The timer increments a counter value

Counter value is transferred to the reload register on the valid edge of a pulse to be

measured. It is set to "000016" and the timer continues counting

Counter Start Condition

The TBiS bits (i=0 to 5) in the TABSR and TBSR register are set to "1" (starts counting)

Counter Stop Condition

The TBiS bit is set to "0" (stops counting)

Interrupt Request Generation Timing • On the valid edge of a pulse to be measured(1)

• The timer counter overflows

The MR3 bit in the TBiMR register is set to "1" (overflow) simultaneously. When the

TBiS bit is set to "1" (start counting) and the next count source is counted after setting

the MR3 bit to "1" (overflow), the MR3 bit can be set to "0" (no overflow) by writing to

the TBiMR register.

TBiIN Pin Function

Input for a pulse to be measured

Read from Timer

The TBi register indicates reload register values (measurement results)(2)

Write to Timer

Value written to the TBi register can be written to neither reload register nor counter

NOTES:

1. No interrupt request is generated when the pulse to be measured is on the first valid edge after the

timer has started counting.

2. The TBi register is in an indeterminate state until the pulse to be measured is on the second valid

edge after the timer has started counting.

3. The CNT3 to CNT0 bits in the TCSPR register select no division (n=0) or divide-by-2n (n=1 to 15).

M32C/86 数据表(PDF) 192 Page - Renesas Technology Corp

M32C/86 数据表(HTML) 192 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载