50-604 Kotron Model 804 Sentinel II RF Level Transmitter

18

2.5.9 Advanced Configuration Menu

This menu is used to set the non-control parameters of the Sentinel II.

Follow this step-by-step procedure to use this menu. It is assumed that you are starting from the

RUN mode.

Current Menu Location

Display

Action

Comments

Run

Magnetrol Int’l

x.x level units

Normal operation

This is the RUN mode.

Run/Adv Config

Adv Config

> to select

Access the Adv Config menu

Use the arrow keys to scroll down until the

display reads Adv Config.

Run/Adv Config/

Damping

Damping (1–60)

6

Set the output damping

Set a damping factor to the 4–20 mA output

to decrease the effect of turbulence. Enter the

number of seconds.

Run/Adv Config/

Damping

Enter password

Accept the data entered

The Enter password display will not appear if a

password has been entered anywhere else in the

general program menu. Use the numeric keys

to enter your password.

Run/Adv Config/

Default Display

Default Display

Level

Set the display for the

run mode

Set the display variable for the RUN mode.

Run/Adv Config/

Change Password

Change Password

> to select

Change the unit’s password

Press ENT only if you want to change the

password; press the down arrow to skip. Enter

the current system password; press ENT. Then

enter the new password; press ENT. Enter the

new password again; press ENT.

Run/Adv Config/

Adjust Loop Pts.

Adjust loop pts.

Calibrate the 4–20 mA output

Allows matching of the actual 4–20 mA output

with the displayed value from the measuring

circuit. Adjustment is factory set and typically

will not need to be readjusted.

Run/Adv Config/

Adjust Loop Pts.

3.5 mA Offset

xxx

Set the 3.5 mA end point

Use a DMM to measure the actual output current,

increase or decrease the xxx value until DMM

reads 3.5 mA. Press ENT.

Run/Adv Config/

Adjust Loop Pts.

22 mA Offset

xxx

Set the 22 mA end point

Use a DMM to measure the actual output current,

increase or decrease the xxx value until DMM

reads 22 mA. Press ENT. Press DOWN arrow.

Run/Adv Config

Previous Menu

> to select

Press DEL two times to return to the RUN mode.

Run

Magnetrol Int’l

x.x level units

Normal operation

This is the RUN mode.