804-R010-330 datasheet(7/32 Pages) MAGNETROL

7 / 32 page

50-604 Kotron Model 804 Sentinel II RF Level Transmitter

3. Screw the amplifier housing onto the probe. Refer to

Figure 2.

4. Screw housing onto the probe unit until hand tight.

Housing may be wrench tightened to align conduit

connection with conduit.

5. Remove housing cover.

NOTE: Refer to Electrostatic Discharge Handling Procedure on

page 9.

6. Remove the electronics assembly from the housing base by

loosening the four mounting screws.

7. Locate the white wire that is fastened to the probe screw

on the circuit board. Connect the free end of this wire to

the probe connection screw.

8. Reinstall the electronics assembly into the housing.

Caution: Check probe terminal connection carefully to ensure that

the lug will not short packing gland or interfere with

assembly of amplifier housing to probe.

9. Proceed to Wiring section on page 9.

2.2.3 Integral Mount with Flexible Probe

Caution: Flexible probes are shipped with the cable clamp and the

probe nut hand-tightened. The end of a flexible probe

must be secured to the bottom of the tank by either

attachment to a bracket or to a heavy weight in order to

keep the probe taut. Follow the mounting instructions

below.

1. Remove mylar housing insulator located over the clamp.

Refer to Figure 3.

Caution: Do not discard the mylar housing insulator.

2. Attach weight, if used, to probe end. Refer to Figure 3.

3. Insert probe end through tank mounting bushing and feed

cable into the tank. Do not allow probe insulation to be

damaged by scraping against the bushing threads.

Caution: Probe cable must not be in contact with anything metallic

in its final installation position.

4. Apply thread sealant to mounting nut.

5. Screw mounting nut into tank bushing until tight.

6. Secure lower end of probe (or optional weight) to tank

bracket if one is used.

Caution: Apply wrench to lower probe nut only.

Figure 3

Integral Mount with

Flexible Probe

Probe wire

(white)

Figure 2

Integral Mount with

Standard Rigid Probe

Probe wire

(white)

804-R010-330 数据表(PDF) 7 Page - Magnetrol International, Inc.

804-R010-330 数据表(HTML) 7 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载