804-R010-330 datasheet(2/32 Pages) MAGNETROL

2 / 32 page

Read this Manual Before Installing

This manual provides information on the Kotron Model

804 Sentinel II RF Level Transmitter. It is important that

all instructions are read carefully and followed

in sequence. Detailed instructions are included in the

Installation section of this manual.

Conventions Used in this Manual

Certain conventions are used in this manual to convey

specific types of information. General technical material,

support data, and safety information are presented in

narrative form. The following styles are used for notes,

cautions, and warnings.

Notes

Notes contain information that augments or clarifies

an operating step. Notes do not normally contain

actions. They follow the procedural steps to which

they refer.

Cautions

Cautions alert the technician to special conditions that

could injure personnel, damage equipment, or reduce

a component’s mechanical integrity. Cautions are also

used to alert the technician to unsafe practices or the

need for special protective equipment or specific

materials. In this manual, a caution box indicates a

potentially hazardous situation which, if not avoided,

may result in minor or moderate injury.

Warnings

Warnings identify potentially dangerous situations or

serious hazards. In this manual, a warning indicates an

imminently hazardous situation which, if not avoided,

could result in serious injury or death.

Safety Messages

Follow all standard industry procedures for servicing elec-

trical equipment when working with or around high

voltage. Always shut off the power supply before touching

any components.

Low Voltage Directive

For use in Category II installations. If equipment is used

in a manner not specified by manufacturer, protection

provided by equipment may be impaired.

WARNING! Explosion hazard. Do not connect or dis-

connect equipment unless power has been switched off or

the area is known to be non-hazardous.

Notice of Trademark, Copyright, and Limitations

Magnetrol & Magnetrol logotype, STI & STI logotype,

Kotron, and Sentinel are registered trademarks of

Magnetrol International, Incorporated. Kotron Model

804 Sentinel II RF Level Transmitter is a tradename of

Magnetrol International, Incorporated.

Performance specifications are effective with date of issue

and are subject to change without notice. Magnetrol

makes no warranty with respect to the accuracy of the

information in this manual.

Warranty

All Magnetrol/STI electronic level and flow controls

are warranted free of defects in materials or workmanship

for one full year from the date of original factory

shipment.

If returned within the warranty period; and, upon factory

inspection of the control, the cause of the claim is deter-

mined to be covered under the warranty; then,

Magnetrol/STI will repair or replace the control at no cost to

the purchaser (or owner) other than transportation.

Magnetrol/STI shall not be liable for misapplication,

labor claims, direct or consequential damage or expense

arising from the installation or use of equipment.

There are no other warranties expressed or implied,

except special written warranties covering some

Magnetrol/STI products.

Quality Assurance

The quality assurance system in place at Magnetrol/STI

guarantees the highest level of quality throughout the

company. Magnetrol/STI is committed to providing full

customer satisfaction both in quality products and

quality service.

Magnetrol’s quality assurance system

is registered to ISO 9001 affirming its

commitment to known international

quality standards providing the

strongest assurance of product/service

quality available.

804-R010-330 数据表(PDF) 2 Page - Magnetrol International, Inc.

804-R010-330 数据表(HTML) 2 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载