| 数据搜索系统,热门电子元器件搜索 |
|
CS9211 数据表(PDF) 13 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
CS9211 数据表(HTML) 13 Page - National Semiconductor (TI) |
|
13 / 62 page ![]() Revision 2.1 13 www.national.com Signal Definitions (Continued) 2.2.5 Reset, Crystal, and GPIO Pins Signal Name Pin No. Type (Drive) Description RESET# 44 I System Reset Input A system reset should be at least as long as one clock cycle of the slowest of DOTCLK, XTALIN or SCLK. RESET# should be active for at least 1 ms. XTALIN 48 I Crystal Oscillator Connection This pin is the crystal input for the on-chip reference oscillator or a CMOS clock input from an external reference source. It should be 14.318 MHz. XTALOUT 49 O Crystal Oscillator Connection This pin is the crystal output for the on-chip reference oscillator. If an exter- nal clock is used, leave this pin unconnected. GPIO0-GPIO7 70:63 I/O (4 mA) General Purpose Inputs/Outputs Each GPIO pin can be configured independently as an input or output. For further programming information refer to Section 3.2.13 “General Purpose I/O Pins” on page 38. 2.2.6 National Semiconductor Internal Test Pins Signal Name Pin No. Type (Drive) Description TEST_SE 47 I Reserved This pin must be tied to ground for normal operation. It is a National Semiconductor internal test mode pin only. MBIST_EN 45 I Reserved This pin must be tied to ground for normal operation. It is a National Semiconductor internal test mode pin only. SCAN_EN 46 I Reserved This pin must be tied to ground for normal operation. It is a National Semiconductor internal test mode pin only. 2.2.7 Power and Ground Pins Signal Name Pin No. Type (Drive) Description VDDIO 1, 17, 37, 55, 72, 91, 108, 125 PWR Power Connection (total of 8 pins) Power for the DRAM and system interface signals. These pins should be supplied with 3.3V. VSSIO 2, 18, 38, 71, 90, 109, 126 GND Ground Connection (total of 7 pins) Ground connection. VDD 36, 73, 144 PWR Power Connection (total of 3 pins) Power for the DRAM and system interface signals. These pins should be supplied with 3.3V. VSS 19, 54, 89, 128 GND Ground Connection (total of 4 pins) Ground connection. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |