| 数据搜索系统,热门电子元器件搜索 |
|
STM32WLE4JC 数据表(PDF) 48 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32WLE4JC 数据表(HTML) 48 Page - STMicroelectronics |
|
48 / 146 page ![]() Functional overview STM32WLE5/E4xx 48/146 DS13105 Rev 9 3.30 Serial peripheral interface (SPI)/integrated-interchip sound interface (I2S) The SPI/I2S interface can be used to communicate with external devices using the SPI protocol or the I2S audio protocol. SPI or I2S mode is selectable by software. SPI Motorola® mode is selected by default after a device reset. The SPI protocol supports half-duplex, full-duplex and simplex synchronous, serial communication with external devices. The SPI interface can be configured as master and, in this case, it provides the communication clock (SCK) to the external slave device. The SPI interface can also operate in multimaster configuration. The I2S protocol is also a synchronous serial communication interface. It can operate in slave or master mode with half-duplex communication. It can address four different audio standards including the Philips I2S standard, the MSB- and LSB-justified standards and the PCM standard. 3.31 Development support Serial-wire JTAG debug port (SWJ-DP) The Arm SWJ-DP interface is embedded, and is a combined JTAG and serial-wire debug port, that enables either a serial-wire debug or a JTAG probe to be connected to the target. The debug is performed using only two pins instead of the five required by the JTAG (JTAG pins can then be reused as GPIOs with alternate function). The JTAG TMS and TCK pins are shared with SWDIO and SWCLK, respectively, and a specific sequence on the TMS pin is used to switch between JTAG-DP and SW-DP. Table 17. SPI and SPI/I2S implementation(1) 1. The SPI1 and SPI2S2 instances are general purpose type while the SUBGHZSPI instance is dedicated for Sub-GHz radio control exclusively. Radio is controlled internally through SUBGHZSPI and, for debug purpose only, from the external. Features SPI1 SPI2S2 SUBGHZSPI Enhanced NSSP and TI modes Yes Hardware CRC calculation Yes Yes No I2S support No Yes No Data size configurable (bits) from 4 to 16 Rx/Tx FIFO size (bits) 32 Wakeup capability from LPSleep Yes |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |