| 数据搜索系统,热门电子元器件搜索 |
|
WM8940CGEFL/RV 数据表(PDF) 57 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8940CGEFL/RV 数据表(HTML) 57 Page - Wolfson Microelectronics plc |
|
57 / 91 page ![]() Production Data WM8940 w PD, Rev 4.3, November 2011 57 LOOPBACK Setting the ADC_LOOPBACK or DAC_LOOPBACK register bit enables digital loopback. When the ADC_LOOPBACK bit is set the output data from the ADC audio interface is fed directly into the DAC data input. When the DAC_LOOPBACK bit is set the output data from the DAC audio interface is fed directly to the input of the ADC audio interface. AUDIO SAMPLE RATES The WM8940 sample rates for the ADC and the DAC are set using the SR register bits. The cutoffs for the digital filters and the ALC attack/decay times stated are determined using these values and assume a 256fs master clock rate. If a sample rate that is not explicitly supported by the SR register settings is required then the closest SR value to that sample rate should be chosen, the filter characteristics and the ALC attack, decay and hold times will scale appropriately. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION R7 Additional control 3:1 SR 000 Approximate sample rate (configures the coefficients for the internal digital filters): 000=48kHz 001=32kHz 010=24kHz 011=16kHz 100=12kHz 101=8kHz 110-111=reserved Table 45 Sample Rate Control MASTER CLOCK AND PHASE LOCKED LOOP (PLL) The WM8940 has an on-chip phase-locked loop (PLL) circuit that can be used to: Generate master clocks for the WM8940 audio functions from another external clock, e.g. in telecoms applications. Generate an output clock, on pin CSB/GPIO, for another part of the system (derived from an existing audio master clock). Figure 30 shows the PLL and internal clocking arrangement on the WM8940. The PLL is enabled or disabled by the PLLEN register bit. Note: In order to minimise current consumption, the PLL is disabled when the VMIDSEL[1:0] bits are set to 00b. VMIDSEL[1:0] must be set to a value other than 00b to enable the PLL. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION R1 Power management 1 5 PLLEN 0 PLL enable 0=PLL off 1=PLL on Table 46 PLLEN Control Bit |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |