STM32F217VG datasheet(36/175 Pages) STMICROELECTRONICS

36 / 175 page

Functional overview

STM32F21xxx

36/175

DocID17050 Rev 9

The ADC can be served by the DMA controller. An analog watchdog feature allows very

precise monitoring of the converted voltage of one, some or all selected channels. An

interrupt is generated when the converted voltage is outside the programmed thresholds.

The events generated by the timers TIM1, TIM2, TIM3, TIM4, TIM5 and TIM8 can be

internally connected to the ADC start trigger and injection trigger, respectively, to allow the

application to synchronize A/D conversion and timers.

3.35

DAC (digital-to-analog converter)

The two 12-bit buffered DAC channels can be used to convert two digital signals into two

analog voltage signal outputs. The design structure is composed of integrated resistor

strings and an amplifier in inverting configuration.

This dual digital Interface supports the following features:

•

two DAC converters: one for each output channel

•

8-bit or 12-bit monotonic output

•

left or right data alignment in 12-bit mode

•

synchronized update capability

•

noise-wave generation

•

triangular-wave generation

•

dual DAC channel independent or simultaneous conversions

•

DMA capability for each channel

•

external triggers for conversion

•

input voltage reference VREF+

Eight DAC trigger inputs are used in the device. The DAC channels are triggered through

the timer update outputs that are also connected to different DMA streams.

3.36

Temperature sensor

The temperature sensor has to generate a voltage that varies linearly with temperature. The

conversion range is between 1.8 and 3.6 V. The temperature sensor is internally connected

to the ADC1_IN16 input channel which is used to convert the sensor output voltage into a

digital value.

As the offset of the temperature sensor varies from chip to chip due to process variation, the

internal temperature sensor is mainly suitable for applications that detect temperature

changes instead of absolute temperatures. If an accurate temperature reading is needed,

then an external temperature sensor part should be used.

3.37

Serial wire JTAG debug port (SWJ-DP)

The ARM SWJ-DP interface is embedded, and is a combined JTAG and serial wire debug

port that enables either a serial wire debug or a JTAG probe to be connected to the target.

The JTAG TMS and TCK pins are shared with SWDIO and SWCLK, respectively, and a

specific sequence on the TMS pin is used to switch between JTAG-DP and SW-DP.

STM32F217VG 数据表(PDF) 36 Page - STMicroelectronics

STM32F217VG 数据表(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载