LSM303D datasheet(39/52 Pages) STMICROELECTRONICS

39 / 52 page

DocID023312 Rev 2

39/52

LSM303D

8.24

STATUS_A (27h)

Table 52. CTRL7 register description

AHPM[1:0]

High-pass filter mode selection for acceleration data. Default value: 00

Refer to Table 53

AFDS

Filtered acceleration data selection. Default value: 0

(0: internal filter bypassed; 1: data from internal filter sent to output register and FIFO)

T_ONLY

Temperature sensor only mode. Default value: 0

If this bit is set to ‘1’, the temperature sensor is on while the magnetic sensor is off.

MLP

Magnetic data low-power mode. Default value: 0

If this bit is ‘1’, the M_ODR [2:0] is set to 3.125 Hz independently from the MODR set-

tings. Once the bit is set to ‘0’, the magnetic data rate is configured by the MODR bits

in the CTRL5 (24h) register.

MD[1:0]

Magnetic sensor mode selection. Default 10

Refer to Table 54

Table 53. High-pass filter mode selection

AHPM1 AHPM0

High-pass filter mode

Normal mode (reset X, Y and Z-axis, reading respective REFERENCE_X

(1Ch), REFERENCE_Y (1Dh) and REFERENCE_Z (1Eh) registers)

Reference signal for filtering

Normal mode

Auto-reset on interrupt event

Table 54. Magnetic sensor mode selection

MD1

MD0

Magnetic sensor mode

Continuous-conversion mode

Single-conversion mode

Power-down mode

Table 55. STATUS_A register

ZYXAOR

ZAOR

YAOR

XAOR

ZYXADA

ZADA

YADA

XADA

LSM303D 数据表(PDF) 39 Page - STMicroelectronics

LSM303D 数据表(HTML) 39 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

数据表下载