| 数据搜索系统,热门电子元器件搜索 |
|
5220-DS02-R 数据表(PDF) 60 Page - Broadcom Corporation. |
|
|
|||||||||||||||||||||||||||||
5220-DS02-R 数据表(HTML) 60 Page - Broadcom Corporation. |
|
60 / 90 page ![]() BCM5220 Preliminary Data Sheet 04/20/04 Broa d c om Co rp o r a t i o n Page 48 Auxiliary Mode 2 Register Document 5220-DS04-405-R Token Ring Mode When enabled, the 100BASE-X unlock timer changes to allow long packets. Block 10BASE-T Echo Mode When enabled, during 10BASE-T half-duplex transmit operation, the TXEN signal does not echo onto the RXDV pin. The TXEN echoes onto the CRS pin and the CRS deassertion directly follows the TXEN deassertion. Traffic Meter LED Mode When enabled, the Activity LEDs (ACTLED# and FDXLED# if full-duplex LED and interrupt LED modes are not enabled) does not blink based on the internal LED clock (approximately 80 ms on time). Instead, they blink based on the rate of Receive and Transmit activity. Each time a Receive or Transmit operation occurs, the LED turns on for a minimum of 5 ms. During light traffic, the LED blinks at a low rate, while during heavier traffic the LEDs remains on. Activity LED Force On When asserted, the Activity LEDs (ACTLED# and FDXLED# if full-duplex LED and interrupt LED modes are not enabled) is turned on. This bit has a higher priority than the Activity LED force Inactive, bit 4, register 1Dh. Activity/Link LED Mode When enabled, the RCVLED# output goes active upon acquiring link and pulses during Receive or Transmit activity. Qualified Parallel Detect Mode This bit allows the auto-negotiation/parallel detection process to be qualified with information in the Advertisement register. If this bit is not set, the local BCM5220 device is enabled to auto-negotiate, and the far-end device is a 10BASE-T or 100BASE-X non-auto-negotiating legacy type, the local device auto-negotiate/parallel detects the far-end device, regardless of the contents of its Advertisement register (04h). If this bit is set, the local device compares the link speed detected to the contents of its Advertisement register. If the particular link speed is enabled in the Advertisement register, the local device asserts link. If the link speed is disabled in this register, then the local device does not assert link and continues monitoring for a matching capability link speed. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |