SAP5SD-B-G1-R datasheet(53/67 Pages) RENESAS

53 / 67 page

SAP51 / SAP5S Datasheet

January 28, 2016

If the Loopback Mode is not active, the AS-i receiver is disabled while the SAP5 is transmitting an AS-i signal.

Otherwise, the transmitted signal is read back in parallel and provided at the RX_DAT output for checkup

purposes.

The loopback time tLOOPBACK is mainly defined by the analog signal processing within the Receiver and the

Transmitter. However, an additional delay of up to 1875ns can be inserted if necessary. Therefore, the

ID_Code_Extension_2 EEPROM register must be programmed as described below.

NOTE: The ID_Code_Extension_2 must be programmed before programming of the Master_Mode flag. Once the

Master_Mode flag is set to logic high, the slave functionality of the SAP5 is no longer available, preventing any

write access to the EEPROM by use of AS-i master requests as described in section 4.3.

Table 5.27 Programmable Variation of the Loopback Time

ID_Code_Extension_2

(ID2_Bit3 to ID2_Bit0)

∆t

loopback

0000

0001

+125ns

0010

+250ns

0011

+375ns

0100

+500ns

0101

+625ns

0110

+750ns

0111

+875ns

1000

+1000ns

1001

+1125ns

1010

+1250ns

1011

+1375ns

1100

+1500ns

1101

+1625ns

1110

+1750ns

1111

+1875ns

SAP5SD-B-G1-R 数据表(PDF) 53 Page - Renesas Technology Corp

SAP5SD-B-G1-R 数据表(HTML) 53 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

数据表下载