H8SLASH3028F datasheet(327/923 Pages) RENESAS

327 / 923 page

Rev. 2.00, 09/03, page 297 of 890

8.12

Port B

8.12.1

Overview

Port B is an 8-bit input/output port that is also used for output (TP15 to TP8) from the

programmable timing pattern controller (TPC), input/output (TMIO3, TMO2, TMIO1, TMO0) by

the 8-bit timer,

7 to CS4 output, input (DREQ1, DREQ0) to the DMA controller (DMAC), input

and output (TxD2, RxD2, SCK2) by serial communication interface channel 2 (SCI2), and output

(

UCAS, LCAS) by the DRAM interface. See table 8.23 to 8.24 for the selection of pin functions.

A reset or hardware standby transition leaves port B as an input port.

For output of

7 to CS4 in modes 1 to 5, see section 6.3.4, Chip Select Signals. When DRAM is

connected to areas 2, 3, 4, and 5, the

4 and CS5 output pins become RAS output pins for these

areas. For details see section 6.5, DRAM Interface. Pins not assigned to any of these functions are

available for generic input/output. Figure 8.11 shows the pin configuration of port B.

When DRAM is connected to areas 2, 3, 4, and 5, the

4 and CS5 output pins become RAS

output pins for these areas. For details see section 6.5, DRAM Interface.

Pins in port B can drive one TTL load and a 30-pF capacitive load. They can also drive darlington

transistor pair.

H8/3028F 数据表(PDF) 327 Page - Renesas Technology Corp