ATtiny13A datasheet(87/174 Pages) ATMEL

87 / 174 page

8126D–AVR–11/09

ATtiny13A

For a summary of conversion times, see Table 14-1.

14.6 Changing Channel or Reference Selection

The MUXn and REFS1:0 bits in the ADMUX Register are single buffered through a temporary

selection only takes place at a safe point during the conversion. The channel and reference

selection is continuously updated until a conversion is started. Once the conversion starts, the

channel and reference selection is locked to ensure a sufficient sampling time for the ADC. Con-

tinuous updating resumes in the last ADC clock cycle before the conversion completes (ADIF in

ADCSRA is set). Note that the conversion starts on the following rising ADC clock edge after

ADSC is written. The user is thus advised not to write new channel or reference selection values

to ADMUX until one ADC clock cycle after ADSC is written.

If Auto Triggering is used, the exact time of the triggering event can be indeterministic. Special

care must be taken when updating the ADMUX Register, in order to control which conversion

will be affected by the new settings.

If both ADATE and ADEN is written to one, an interrupt event can occur at any time. If the

ADMUX Register is changed in this period, the user cannot tell if the next conversion is based

on the old or the new settings. ADMUX can be safely updated in the following ways:

• When ADATE or ADEN is cleared.

• During conversion, minimum one ADC clock cycle after the trigger event.

• After a conversion, before the Interrupt Flag used as trigger source is cleared.

When updating ADMUX in one of these conditions, the new settings will affect the next ADC

conversion.

14.6.1

ADC Input Channels

When changing channel selections, the user should observe the following guidelines to ensure

that the correct channel is selected:

In Single Conversion mode, always select the channel before starting the conversion. The chan-

nel selection may be changed one ADC clock cycle after writing one to ADSC. However, the

simplest method is to wait for the conversion to complete before changing the channel selection.

In Free Running mode, always select the channel before starting the first conversion. The chan-

nel selection may be changed one ADC clock cycle after writing one to ADSC. However, the

simplest method is to wait for the first conversion to complete, and then change the channel

selection. Since the next conversion has already started automatically, the next result will reflect

the previous channel selection. Subsequent conversions will reflect the new channel selection.

Table 14-1.

ADC Conversion Time

Condition

Sample & Hold (Cycles

from Start of Conversion)

Conversion Time (Cycles)

First conversion

13.5

Normal conversions

1.5

Auto Triggered conversions

13.5

ATtiny13A 数据表(PDF) 87 Page - ATMEL Corporation

ATtiny13A 数据表(HTML) 87 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载