ST7LITE25F2 datasheet(82/166 Pages) STMICROELECTRONICS

82 / 166 page

On-chip peripherals

ST7LITE20F2 ST7LITE25F2 ST7LITE29F2

82/166

Doc ID 8349 Rev 5

Break control register (BREAKCR)

Read/Write

Reset Value: 0000 0000 (00h)

●

Bits 7:6 = Reserved. Forced by hardware to 0.

●

Bit 5 =

BA Break Active

This bit is read/write by software, cleared by hardware after reset and set by hardware

when the BREAK pin is low. It activates/deactivates the Break function.

0: Break not active

1: Break active

●

Bit 4 =

BPEN Break pin enable

This bit is read/write by software and cleared by hardware after Reset.

0: Break pin disabled

1: Break pin enabled

●

Bits 3:0 =

PWM[3:0] Break pattern

These bits are read/write by software and cleared by hardware after a reset. They are

used to force the four PWMx output signals into a stable state when the Break function

is active.

PWMx duty cycle register high (DCRxH)

Read / Write

Reset Value: 0000 0000 (00h)

PWMx duty cycle register low (DCRxL)

Read / Write

Reset value: 0000 0000 (00h)

●

Bits 15:12 = Reserved

●

Bits 11:0 =

DCR[11:0] PWMx duty cycle value

This 12-bit value is written by software. It defines the duty cycle of the corresponding

PWM output signal (see Figure 36).

In PWM mode (OEx=1 in the PWMCR register) the DCR[11:0] bits define the duty

cycle of the PWMx output signal (see Figure 36). In Output Compare mode, they define

the value to be compared with the 12-bit upcounter value.

BPEN

PWM3

PWM2

PWM1

PWM0

DCR11

DCR10

DCR9

DCR8

DCR7

DCR6

DCR5

DCR4

DCR3

DCR2

DCR1

DCR0

ST7LITE25F2 数据表(PDF) 82 Page - STMicroelectronics

ST7LITE25F2 数据表(HTML) 82 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载