MMPF0200Z datasheet(73/118 Pages) NXP

73 / 118 page

Analog Integrated Circuit Device Data



Freescale Semiconductor

PF0200Z

Functional Block Requirements and Behaviors

Power Generation

VGEN1 AC AND TRANSIENT

PSRR(52)

•IGEN1 = 75 mA, 20 Hz to 20 kHz

VGEN1[3:0] = 0000 - 1101

VGEN1[3:0] = 1110, 1111

PSRRVGEN1

–

Output Noise Density

VIN1 = 1.75 V, IGEN1 = 75 mA

100 Hz – <1.0 kHz

1.0 kHz – <10 kHz

10 kHz – 1.0 MHz

NOISEVGEN1

–

-108

-118

-124

-100

-108

-112

dBV/

Hz

Turn-on Slew Rate

• 10% to 90% of end value

•1.75 V

VIN1  3.4 V, IGEN1 = 0.0 mA

VGEN1[3:0] = 0000 to 0111

VGEN1[3:0] = 1000 to 1111

SLWRVGEN1

–

12.5

16.5

s

Turn-On Time

Enable to 90% of end value, VIN1 = 1.75 V, 3.4 V

IGEN1 = 0.0 mA

GEN1tON

–

500

s

Turn-Off Time

Disable to 10% of initial value, VIN1 = 1.75 V

IGEN1 = 0.0 mA

GEN1tOFF

––

Start-Up Overshoot

VIN1 = 1.75 V, 3.4 V, IGEN1 = 0.0 mA

GEN1OSHT

–1.0

2.0

Transient Load Response

•VIN1 = 1.75 V, 3.4 V

IGEN1 = 10 to 100 mA in 1.0 s. Peak of overshoot or undershoot

of VGEN1 with respect to final value

• Refer to Figure 20

VGEN1LOTR

––

3.0

Transient Line Response

•IGEN1 = 75 mA

VIN1INITIAL = 1.75 V to VIN1FINAL = 2.25 V for 

VGEN1[3:0] = 0000 to 1101

VIN1INITIAL = VGEN1+0.3 V to VIN1FINAL = VGEN1+0.8 V for

VGEN1[3:0] = 1110, 1111

• Refer to Figure 20

VGEN1LITR

–5.0

8.0

Notes

52.

The PSRR of the regulators is measured with the perturbing signal at the input of the regulator. The power management IC is supplied

separately from the input of the regulator and does not contain the perturbed signal. During measurements, care must be taken not to

operate in the dropout region of the regulator under test.

Table 86. VGEN1 Electrical Characteristics (continued)

All parameters are specified at TA = -40 to 85 °C, VIN = 3.6 V, VIN1 = 3.0 V, VGEN1[3:0] = 1111, IGEN1 = 10 mA, typical external

component values, unless otherwise noted. Typical values are characterized at VIN = 3.6 V, IN1 = 3.0 V, VGEN1[3:0] = 1111,

IGEN1 = 10 mA, and 25 °C, unless otherwise noted.

Parameter

Symbol

Min

Typ

Max

Unit

MMPF0200Z 数据表(PDF) 73 Page - NXP Semiconductors

MMPF0200Z 数据表(HTML) 73 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载