LSM6DSOX datasheet(105/199 Pages) STMICROELECTRONICS

105 / 199 page

11.11

SPI2_CTRL1_OIS (70h)

OIS configuration register. The auxiliary SPI interface can write this register when the OIS_CTRL_FROM_UI bit in

the FUNC_CFG_ACCESS (01h) register is equal to 0 (SPI2 Full control mode); this register is read-only when the

OIS_CTRL_FROM_UI bit is equal to 1 (Primary IF Full control mode) and shows the content of the UI_INT_OIS

(6Fh) register.

Table 230. SPI_CTRL1_OIS register

LVL1_OIS

SIM_OIS

Mode4_EN

FS1_G_OIS

FS0_G_OIS

FS_125_OIS

OIS_EN_SPI2

Table 231. SPI_CTRL1_OIS register description

LVL1_OIS

Enables level-sensitive trigger mode on the OIS chain. Default value: 0

SIM_OIS

SPI2 3- or 4-wire interface. Default value: 0

(0: 4-wire SPI2;

1: 3-wire SPI2)

Mode4_EN

Enables accelerometer OIS chain. OIS outputs are available through SPI2 in registers

SPI2_OUTX_L_A_OIS (28h) and SPI2_OUTX_H_A_OIS (29h) through SPI2_OUTZ_L_A_OIS (2Ch) and

SPI2_OUTZ_H_A_OIS (2Dh) and SPI2_STATUS_REG_OIS (1Eh).

Note: OIS_EN_SPI2 must be enabled (i.e. set to ‘1’) to enable also the XL OIS chain.

FS[1:0]_G_OIS

Selects gyroscope OIS chain full-scale

(00: 250 dps;

01: 500 dps;

10: 1000 dps;

11: 2000 dps)

FS_125_OIS

Selects gyroscope OIS chain full-scale 125 dps

(0: FS selected through bits FS[1:0]_OIS_G;

1: 125 dps)

OIS_EN_SPI2

Enables OIS chain data processing for gyro in Mode 3 and Mode 4 (mode4_en = 1) and accelerometer data

in and Mode 4 (mode4_en = 1).

When the OIS chain is enabled, the OIS outputs are available through the SPI2 in registers

SPI2_OUTX_L_G_OIS (22h) and SPI2_OUTX_H_G_OIS (23h) through SPI2_OUTZ_L_G_OIS (26h) and

SPI2_OUTZ_H_G_OIS (27h) and STATUS_REG (1Eh) and SPI2_STATUS_REG_OIS (1Eh), and LPF1 is

dedicated to this chain.

DEN mode selection can be done using the LVL1_OIS bit of register UI_CTRL1_OIS (70h) and the LVL2_OIS bit

of register UI_INT_OIS (6Fh).

DEN mode on the OIS path is active in the gyroscope only.

Table 232. DEN mode selection

LVL1_OIS, LVL2_OIS

DEN mode

Level-sensitive trigger mode is selected

Level-sensitive latched mode is selected

LSM6DSOX

SPI2_CTRL1_OIS (70h)

DS12814 - Rev 3

page 105/199

LSM6DSOX 数据表(PDF) 105 Page - STMicroelectronics

LSM6DSOX 数据表(HTML) 105 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载