ST7LITE49M datasheet(21/188 Pages) STMICROELECTRONICS

21 / 188 page

ST7LITE49M

Flash programmable memory

21/188

Flash programmable memory

4.1

Introduction

The ST7 single voltage extended Flash (XFlash) is a non-volatile memory that can be

electrically erased and programmed either on a byte-by-byte basis or up to 32 bytes in

parallel.

The XFlash devices can be programmed off-board (plugged in a programming tool) or on-

board using In-Circuit Programming or In-Application Programming.

The array matrix organization allows each sector to be erased and reprogrammed without

affecting other sectors.

4.2

Main features

●

ICP (In-Circuit Programming)

●

IAP (In-Application Programming)

●

ICT (In-Circuit Testing) for downloading and executing user application test patterns in

RAM

●

Sector 0 size configurable by option byte

●

Read-out and write protection

4.3

Programming modes

The ST7 can be programmed in three different ways:

●

Insertion in a programming tool. In this mode, Flash sectors 0 and 1, option byte row

and data EEPROM (if present) can be programmed or erased.

●

In-Circuit Programming. In this mode, Flash sectors 0 and 1, option byte row and data

EEPROM (if present) can be programmed or erased without removing the device from

the application board.

●

In-Application Programming. In this mode, sector 1 and data EEPROM (if present) can

be programmed or erased without removing the device from the application board and

while the application is running.

4.3.1

In-Circuit Programming (ICP)

ICP uses a protocol called ICC (In-Circuit Communication) which allows an ST7 plugged on

a printed circuit board (PCB) to communicate with an external programming device

connected via cable. ICP is performed in three steps:

Switch the ST7 to ICC mode (In-Circuit Communications). This is done by driving a specific

signal sequence on the ICCCLK/DATA pins while the RESET pin is pulled low. When the

ST7 enters ICC mode, it fetches a specific Reset vector which points to the ST7 System

Memory containing the ICC protocol routine. This routine enables the ST7 to receive bytes

from the ICC interface.

●

Download ICP Driver code in RAM from the ICCDATA pin

●

ST7LITE49M 数据表(PDF) 21 Page - STMicroelectronics

ST7LITE49M 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载