STLS2F02 datasheet(21/49 Pages) STMICROELECTRONICS

21 / 49 page

STLS2F02

DDR2 SDRAM controller interface description

21/49

DDR2 SDRAM controller interface description

The STLS2F02 integrates a built-in memory controller compliant with DDR2 SDRAM

standard (JESD79-2B). The STLS2F02 provides JESD79-2B-compliant read/write memory

operations.

4.1

DDR2 SDRAM controller features

The STLS2F01 CPU supports up to 4 physical memories by using two DDR SDRAM chip

select signals, with an 18-bit address bus (15-bit row/column address and 3-bit logic bank

bus). The maximum address space is 128 Gbytes (237 bytes).

This device supports all the JESD79-2B-compatible memory chips. The DDR2 controller

parameters can be set to support specific memory chip type. The maximum number of chip

selection (CS_n) is 2-bit. The maximum width of row address (RAS_n) is 15-bit, and the

maximum width of column address (CAS_n) is 14-bit. And there is 3-bit logic bank bus

(BANK_n).

For example, in the 4 Gbyte address space configuration of 2-bit CS_n, 3-bit BANK_n,

12-bit RAS_n and 12-bit CAS_n, the physical memory address CPU required can be

translated into row/column address as shown in Figure 7: DDR2 SDRAM row/column

address translation.

Figure 7.

DDR2 SDRAM row/column address translation

The built-in memory controller IC receives only memory read/write requests from a

processor or external device. The controller IC is in slave state whenever memory are read

or written.

A dynamic page management policy is implemented on the integrated memory controller.

For one access to memory, the controller selects open page/close page strategies on a

hardware circuit, without software designers’ intervention. The memory controller features:

●

Full pipelining support to command and read/write data of interface

●

Increasing bandwidth by merging and sorting memory command

●

Modify fundamental parameters through the configuration of register read/write ports

●

Built-in delay compensation circuit (DCC), it is used to send/receive data reliably

●

1-bit and 2-bit error detection, 1-bit error correction by error correcting-code (ECC)

●

Frequency: 133 MHz to 333 MHz.

32 31

30 29

18 17

15 14

3 2

CS_n

RAS_n

BANK_n

CAS_n

Byte_enable

STLS2F02 数据表(PDF) 21 Page - STMicroelectronics

STLS2F02 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

数据表下载