SH7708 datasheet(163/633 Pages) RENESAS

163 / 633 page

145

8.3

Sleep Mode

8.3.1

Transition to Sleep Mode

Executing the SLEEP instruction when the STBY bit in STBCR is 0 causes a transition from the

program execution state to sleep mode. Although the CPU halts immediately after executing the

SLEEP instruction, the contents of its internal registers remain unchanged. The on-chip supporting

modules continue to run during sleep mode and the clock continues to be output to the CKIO pin.

In sleep mode, the STATUS1 pin is set high and the STATUS0 pin low. However, during a

refresh cycle, the STATUS1 pin and STATUS0 pin are both set low.

8.3.2

Canceling Sleep Mode

Sleep mode is canceled by an interrupt (NMI, IRL, on-chip supporting module) or reset. Interrupts

are accepted during sleep mode even when the BL bit in the SR register is 1.

Canceling with an Interrupt: When an NMI, IRL or on-chip supporting module interrupt occurs,

sleep mode is canceled and interrupt exception handling is executed. A code indicating the

interrupt source is set in the INTEVT register.

Canceling with a Reset: Sleep mode is canceled by a power-on reset or a manual reset.

8.4

Standby Mode

8.4.1

Transition to Standby Mode

To enter standby mode, set the STBY bit to 1 in STBCR, then execute the SLEEP instruction. The

chip moves from the program execution state to standby mode. In standby mode, power

consumption is greatly reduced by halting not only the CPU, but the clock and on-chip supporting

modules as well. The clock output from the CKIO pin also halts. CPU and cache register contents

are held, but some on-chip supporting modules are initialized. Table 8.4 lists the states of registers

in standby mode.

SH7708 数据表(PDF) 163 Page - Renesas Technology Corp