H8SLASH3028F datasheet(381/923 Pages) RENESAS

381 / 923 page

Rev. 2.00, 09/03, page 351 of 890

Sample Setup Procedure for PWM Mode: Figure 9.26 shows a sample procedure for setting up

PWM mode.

PWM mode

Set bits TPSC2 to TPSC0 in 16TCR to

select the counter clock source. If an

external clock source is selected, set

bits CKEG1 and CKEG0 in 16TCR to

select the desired edge(s) of the

external clock signal.

Set bits CCLR1 and CCLR0 in 16TCR

to select the counter clear source.

Set the time at which the PWM

waveform should go to 1 in GRA.

Set the time at which the PWM

waveform should go to 0 in GRB.

Set the PWM bit in TMDR to select

PWM mode. When PWM mode is

selected, regardless of the TIOR

contents, GRA and GRB become

output compare registers specifying

the times at which the PWM output

goes to 1 and 0. The TIOCA pin

automatically becomes the PWM

output pin. The TIOCB pin conforms

to the settings of bits IOB1 and IOB0

in TIOR. If TIOCB output is not

desired, clear both IOB1 and IOB0 to 0.

Set the STR bit to 1 in TSTR to start

the timer counter.

PWM mode

Select counter clock

Select counter clear source

Set GRA

Set GRB

Select PWM mode

Start counter

Figure 9.26 Setup Procedure for PWM Mode (Example)

H8/3028F 数据表(PDF) 381 Page - Renesas Technology Corp

H8/3028F 数据表(HTML) 381 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载