| 数据搜索系统,热门电子元器件搜索 |
|
521 数据表(PDF) 92 Page - Intel Corporation |
|
|
|||||||||||||||||||||||||||||
521 数据表(HTML) 92 Page - Intel Corporation |
|
92 / 96 page ![]() 92 Datasheet Boxed Processor Specifications The fan heatsink outputs a SENSE signal that is an open-collector output that pulses at a rate of 2 pulses per fan revolution. A baseboard pull-up resistor provides VOH to match the system board- mounted fan speed monitor requirements, if applicable. Use of the SENSE signal is optional. If the SENSE signal is not used, pin 3 of the connector should be tied to GND. The fan heatsink receives a PWM signal from the motherboard from the 4th pin of the connector labeled as CONTROL. The boxed processor's fan heatsink requires a constant +12 V supplied to pin 2 and does not support variable voltage control or 3-pin PWM control. The power header on the baseboard must be positioned to allow the fan heatsink power cable to reach it. The power header identification and location should be documented in the platform documentation, or on the system board itself. Figure 7-6 shows the location of the fan power connector relative to the processor socket. The baseboard power header should be positioned within 110 mm [4.33 inches] from the center of the processor socket. Figure 7-5. Boxed Processor Fan Heatsink Power Cable Connector Description Table 7-1. Fan Heatsink Power and Signal Specifications Description Min Typ Max Unit Notes +12 V: 12 volt fan power supply 10.2 12 13.8 V - IC: Peak Fan current draw Fan start-up current draw Fan start-up current draw maximum duration — 1.1 — — 1.5 2.2 1.0 A A Second - SENSE: SENSE frequency — 2 — pulses per fan revolution 1 NOTES: 1. Baseboard should pull this pin up to 5V with a resistor. CONTROL 21 25 28 kHz 2, 3 2. Open drain type, pulse width modulated. 3. Fan will have pull-up resistor to 4.75 V maximum of 5.25 V. Boxed_Proc_PwrCable Pin Signal 12 34 1 2 3 4 GND +12 V SENSE CONTROL Straight square pin, 4-pin terminal housing with polarizing ribs and friction locking ramp. 0.100" pitch, 0.025" square pin width. Match with straight pin, friction lock header on mainboard. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |