521 datasheet(17/96 Pages) INTEL

17 / 96 page

Datasheet

Electrical Specifications

2.4

Voltage Identification

The VID specification for the Pentium 4 processor in the 775-land package is supported by the

Voltage Regulator Down (VRD) 10.1 Design Guide For Desktop LGA775 Socket. The voltage set

by the VID signals is the reference VR output voltage to be delivered to the processor VCC pins. A

minimum voltage is provided in Table 2-8 and changes with frequency. This allows processors

running at a higher frequency to have a relaxed minimum voltage specification. The specifications

have been set such that one voltage regulator can work with all supported frequencies.

Individual processor VID values may be calibrated during manufacturing such that two devices at

the same speed may have different VID settings.

The Pentium 4 processor in the 775-land package uses six voltage identification signals, VID[5:0],

to support automatic selection of power supply voltages. Table 2-2 specifies the voltage level

corresponding to the state of VID[5:0]. A ‘1’ in this table refers to a high voltage level and a ‘0’

refers to low voltage level. If the processor socket is empty (VID[5:0] = x11111), or the voltage

regulation circuit cannot supply the voltage that is requested, it must disable itself. See the Voltage

Regulator Down (VRD) 10.1 Design Guide For Desktop LGA775 Socket for more details.

Power source characteristics must be guaranteed to be stable when the supply to the voltage

regulator is stable.

The LL_ID[1:0] lands are used by the platform to configure the proper loadline slope for the

processor. LL_ID[1:0] = 00 for the Pentium 4 processor in the 775-land package.

The VTT_SEL land is used by the platform to configure the proper VTT voltage level for the

processor. VTT_SEL = 1 for the Pentium 4 processor in the 775-land package.

The GTLREF_SEL signal is used by the platform to select the appropriate chipset GTLREF level.

GTLREF_SEL = 0 for the Pentium 4 processor in the 775-land package.

LL_ID[1:0] and VTT_SEL are signals that are implemented on the processor package. That is,

they are either connected directly to VSS or are open lands.

521 数据表(PDF) 17 Page - Intel Corporation