WM8321 datasheet(132/253 Pages) WOLFSON

132 / 253 page

WM8321

Production Data

PD, February 2012, Rev 4.0

132

24.4 SUPPLY VOLTAGE MONITORING

The WM8321 includes a number of mechanisms to prevent the system from starting up, or to force it

to shut down, when the power sources are critically low.

The internal regulator LDO12 is powered from an internal domain equivalent to PVDD and generates

an internal supply (VPMIC) to support various “always-on” functions. In the absence of the PVDD

supply, LDO12 can be powered from a backup battery. (Note that PVDD is not maintained by the

backup battery.) The VPMIC monitoring function controls the Power-On Reset circuit, which sets the

threshold below which the WM8321 cannot operate.

The operation of the VPMIC monitoring circuit is illustrated in Figure 26. The internal signal PORRST

¯¯¯¯¯¯¯

is governed by the VPOR thresholds. These determine when the WM8321 is kept in the NO POWER

state. The internal signal PMICRST

¯¯¯¯¯¯¯¯ is governed by the VRES thresholds. These determine when the

WM8321 is kept in the BACKUP state.

The VPMIC monitoring thresholds illustrated in Figure 26 are fixed. The voltage levels are defined in

the Electrical Characteristics - see Section 7.3.

Figure 26 VPMIC Monitoring

The operation of the PVDD monitoring circuit is illustrated in Figure 27. The VSHUTDOWN threshold is the

voltage below which the WM8321 forces an OFF transition. This threshold voltage is fixed and is

defined in the Electrical Characteristics - see Section 7.3.

The VSYSOK threshold is the level at which the internal signal SYSOK is asserted. Any ON request will

be inhibited if SYSOK is not set. The VSYSOK threshold can be set using the SYSOK_THR register field

in accordance with the minimum voltage requirements of the application. Note that a hysteresis

margin is added to the SYSOK_THR setting; see Section 7.3 for details.

The VSYSLO threshold is the level at which the internal signal SYSLO is asserted. This indicates a

PVDD undervoltage condition, at which a selectable response can be initiated. The VSYSLO threshold

can be set using the SYSLO_THR register field. The action taken under this undervoltage condition is

selected using the SYSLO_ERR_ACT register field, as defined in Table 78. An Interrupt event is

associated with the SYSLO condition - see Section 17.2.

The SYSLO status can be read from the SYSLO_STS register bit. This bit is asserted when PVDD is

below the SYSLO threshold.

WM8321 数据表(PDF) 132 Page - Wolfson Microelectronics plc

WM8321 数据表(HTML) 132 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载